MD4331-Dxx M-Systems, MD4331-Dxx Datasheet - Page 16

• Manufacturer Part Number: MD4331-Dxx
• Description: Mobile DiskOnChip G3 512Mbit/1Gbit Flash Disk
• Manufacturer: M-Systems

www.DataSheet4U.com
13
The following abbreviations are used: IN - Standard (non-Schmidt) input, ST - Schmidt Trigger input, OD - Open drain output, R8 - Nominal
22K pull-up resistor, enabled only for 8-bit interface mode (IF_CFG input is 0)
IRQ#
DPD
VCC
VCCQ
VSS
RSRVD
Signal
See Figure 2
Ball No.
G2, J8
G1
F8
J4
J5
M
A
Input
Type
OD
ST
-
-
-
-
-
-
Interrupt Request, active low. A 10 KΩ pull-up
resistor is required if this ball drives an input. A 10
KΩ pull-up resistor is recommended even if this
ball is not used.
Deep Power-Down. Used to enter and exit Deep
Power-Down mode. This ball is assigned A0
instead of DPD when working in 8-bit mode.
Device supply. Requires a 10 nF and 0.1 µF
capacitor.
I/O power supply. Sets the logic 1 voltage level
range of I/O balls. VCCQ may be either 2.5V to
3.6V or 1.65V to 2.0V. Requires a 10 nF and
0.1 µF capacitor.
Ground. All VSS balls must be connected.
Reserved. All reserved signals are not connected
internally and must be left floating to guarantee
forward compatibility with future products.
Mechanical. These balls are for mechanical
placement, and are not connected internally.
Alignment. This ball is for device alignment and is
not connected internally.
Data Sheet, Rev. 1.0
Power
Other
Description
Mobile DiskOnChip G3
91-SR-011-05-8L
Supply
Supply
Supply
Signal
Output
Type
Input