HT45R34 Holtek Semiconductor, HT45R34 Datasheet - Page 21

• Manufacturer Part Number: HT45R34
• Description: C/R to F Type 8-Bit OTP MCU
• Manufacturer: Holtek Semiconductor

www.DataSheet4U.com
C to F Application Circuit 2
Note: 1. Crystal/resonator system oscillators
Rev. 1.20
2. Reset circuit
3. For applications where noise may interfere with the reset circuit and for details on the oscillator external com-
4. The *R resistance and *C capacitance should be consideration for the frequency of RC OSC.
5. R
6. C
For crystal oscillators, C1 and C2 are only required for some crystal frequencies to ensure oscillation. For
resonator applications C1 and C2 are normally required for oscillation to occur. For most applications it is not
necessary to add R1. However if the LVR function is disabled, and if it is required to stop the oscillator when
VDD falls below its operating range, it is recommended that R1 is added. The values of C1 and C2 should be
selected in consultation with the crystal/resonator manufacturer specifications.
The reset circuit resistance and capacitance values should be chosen to ensure that VDD is stable and re-
mains within its operating voltage range before the RES pin reaches a high level. Ensure that the length of
the wiring connected to the RES pin is kept as short as possible, to avoid noise interference.
ponents, refer to Application Note HA0075E for more information.
sensor
sensor
1~R
1~C
sensor
sensor
12 are the resistance sensors.
12 are the capacitance sensors.
21
October 15, 2007
HT45R34