ST62T42B ST Microelectronics, ST62T42B Datasheet - Page 32
![no-image](/images/no-image-200.jpg)
ST62T42B
Manufacturer Part Number
ST62T42B
Description
8-BIT OTP/EPROM MCU WITH LCD DRIVER / EEPROM AND A/D CONVERTER
Manufacturer
ST Microelectronics
Datasheet
1.ST62T42B.pdf
(68 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
ST62T42B/E42B
4 ON-CHIP PERIPHERALS
4.1 I/O PORTS
The MCU features Input/Output lines which may
be individually programmed as any of the following
input or output configurations:
– Input without pull-up or interrupt
– Input with pull-up and interrupt
– Input with pull-up, but without interrupt
– Analog input
– Push-pull output
– Open drain output
The lines are organised as bytewise Ports.
Each port is associated with 3 registers in Data
space. Each bit of these registers is associated
with a particular line (for instance, bits 0 of Port A
Data, Direction and Option registers are associat-
ed with the PA0 line of Port A).
The DATA registers (DRx), are used to read the
voltage level values of the lines which have been
configured as inputs, or to write the logic value of
the signal to be output on the lines configured as
outputs. The port data registers can be read to get
the effective logic levels of the pins, but they can
Figure 17. I/O Port Block Diagram
32/68
32
S
IN
REGIST ER
S
CONTROLS
SHIFT
OUT
TO INTERRU PT
TO ADC
RESET
DIRECTION
REGISTE R
REGISTE R
REGISTE R
OPTION
DATA
DATA
be also written by user software, in conjunction
with the related option registers, to select the dif-
ferent input mode options.
Single-bit operations on I/O registers are possible
but care is necessary because reading in input
mode is done from I/O pins while writing will direct-
ly affect the Port data register causing an unde-
sired change of the input configuration.
The Data Direction registers (DDRx) allow the
data direction (input or output) of each pin to be
set.
The Option registers (ORx) are used to select the
different port options available both in input and in
output mode.
All I/O registers can be read or written to just as
any other RAM location in Data space, so no extra
RAM cells are needed for port data storage and
manipulation. During MCU initialization, all I/O reg-
isters are cleared and the input mode with pull-ups
and no interrupt generation is selected for all the
pins, thus avoiding pin conflicts.
V
DD
V
DD
INPUT /OUTPUT
VA00413