S25FL032A Meet Spansion Inc., S25FL032A Datasheet - Page 19

• Manufacturer Part Number: S25FL032A
• Description: 32 Megabit Cmos 3.0 Volt Flash Memory With 50 Mhz Spi Bus Interface
• Manufacturer: Meet Spansion Inc.

9.4
9.5
July 2, 2007 S25FL032A_00_C2
Write Enable (WREN)
Write Disable (WRDI)
The Write Enable (WREN) command (see
enables the device to accept a Write Status Register, program, or erase command. The WEL bit must be set
prior to every Page Program (PP), Erase (SE or BE) and Write Status Register (WRSR) command.
The host system must first drive CS# low, write the WREN command, and then drive CS# high.
The Write Disable (WRDI) command (see
disables the device from accepting a Write Status Register, program, or erase command. The host system
must first drive CS# low, write the WRDI command, and then drive CS# high.
Any of following conditions resets the WEL bit:
Power-up
Write Disable (WRDI) command completion
Write Status Register (WRSR) command completion
Page Program (PP) command completion
Sector Erase (SE) command completion
Bulk Erase (BE) command completion
D a t a
CS#
SCK
SO
SI
Figure 9.4 Write Enable (WREN) Command Sequence
Figure 9.5 Write Disable (WRDI) Command Sequence
SCK
CS#
SO
SI
Mode 3
Mode 0
Mode 3
Mode 0
Hi-Z
Hi-Z
S h e e t
S25FL032A
Figure
Figure
0 1
0 1 2 3 4 5 6 7
9.5) resets the Write Enable Latch (WEL) bit to a 0, which
9.4) sets the Write Enable Latch (WEL) bit to a 1, which
2 3
Command
Command
4 5 6 7
19