s29gl-p Meet Spansion Inc., s29gl-p Datasheet - Page 38

• Manufacturer Part Number: s29gl-p
• Description: 3.0 Volt-only Page Mode Flash Memory Featuring 90 Nm Mirrorbit Process Technology
• Manufacturer: Meet Spansion Inc.

36
7.9.3
Software Reset
Note
Hardware reset operation during embedded erase is not recommended; permanent device damage may
result.
Software reset is part of the command set (see
read mode and must be used for the following conditions:
Software Functions and Sample Code
Note
Base = Base Address.
The following is a C source code example of using the reset function. Refer to the Spansion Low Level Driver
User’s Guide (available on www.spansion.com) for general information on Spansion Flash memory software
development guidelines.
The following are additional points to consider when using the reset command:
T This command resets the sectors to the read and address bits are ignored.
T Reset commands are ignored once erasure has begun until the operation is complete.
T Once programming begins, the device ignores reset commands until the operation is complete
T The reset command may be written between the cycles in a program command sequence before
T If the program command sequence is written to a sector that is in the Erase Suspend mode, writing the
T The reset command may be also written during an Autoselect command sequence.
T If a sector has entered the Autoselect mode while in the Erase Suspend mode, writing the reset command
T If DQ1 goes high during a Write Buffer Programming operation, the system must write the "Write to Buffer
T To exit the unlock bypass mode, the system must issue a two-cycle unlock bypass reset command
/* Example: Reset (software reset of Flash state machine) */
programming begins (prior to the third cycle). This resets the sector to which the system was writing to the
read mode.
reset command returns that sector to the erase-suspend-read mode.
returns that sector to the erase-suspend-read mode.
Abort Reset" command sequence to RESET the device to reading array data. The standard RESET
command does not work during this condition.
sequence [see command table for details].
1. to exit Autoselect mode
2. when DQ5 goes high during write status operation that indicates program or erase cycle was not
3. exit sector lock/unlock operation.
4. to return to erase-suspend-read mode if the device was previously in Erase Suspend mode.
5. after any aborted operations
*( (UINT16 *)base_addr + 0x000 ) = 0x00F0;
successfully completed
Reset Command
Cycle
D a t a
S29GL-P MirrorBit
S h e e t
Operation
(LLD Function = lld_ResetCmd)
Write
Table 7.18 Reset
( A d v a n c e
TM
Table 12.1 on page
Flash Family
Byte Address
Base + xxxh
I n f o r m a t i o n )
61) that also returns the device to array
Word Address
Base + xxxh
S29GL-P_00_A3 November 21, 2006
00F0h
Data