upc1658g Renesas Electronics Corporation., upc1658g Datasheet - Page 8

• Manufacturer Part Number: upc1658g
• Description: Low Noise, High Frequency Si Mmic Amplifier
• Manufacturer: Renesas Electronics Corporation.

NOTES ON CORRECT USE
RECOMMENDED SOLDERING CONDITIONS
conditions other than those recommended below, contact your NEC sales representative.
SEMICONDUCTOR DEVICE MOUNTING TECHNOLOGY MANUAL (C10535E).
8
Infrared Reflow
VPS
Wave Soldering
Partial Heating
Soldering Method
(1) Observe precautions for handling because of electro-static sensitive devices.
(2) Form a ground pattern as widely as possible to minimize ground impedance (to prevent undesired oscillation).
(3) Because the components will operate at high frequencies, apply chip capacitors and chip resistors with low
(4) The DC capacitor must be attached to input pin and output pin.
(5) The bypass capacitor should be attached to V
(6) In case of improved output level type application circuit, observe precaution not to exceed the power
This product should be soldered under the following recommended conditions.
Note After opening the dry pack, keep it in a place below 25 °C and 65 % RH for the allowable storage period.
Caution Do not use different soldering methods together (except for partial heating).
For details of recommended soldering conditions for surface mounting, refer to information document
All the ground pins must be connected together with wide ground pattern to decrease impedance difference.
parasitic inductance.
dissipation rating, especially in V
Package peak temperature: 235 ° C or below
Time: 30 seconds or less (at 210 ° C)
Count: 3, Exposure limit: None
Package peak temperature: 215 ° C or below
Time: 40 seconds or less (at 200 ° C)
Count: 3, Exposure limit: None
Soldering bath temperature: 260 ° C or below
Time: 10 seconds or less
Count: 1, Exposure limit: None
Pin temperature: 300 ° C
Time: 3 seconds or less (per side of device)
Exposure limit: None
CC
Note
= 9 V or over.
Soldering Conditions
Data Sheet P11120EJ3V0DS00
Note
Note
Note
CC
line.
Recommended Condition Symbol
For soldering methods and
WS60-00-1
VP15-00-3
IR35-00-3
–
PC1658G