mpc8536e Freescale Semiconductor, Inc, mpc8536e Datasheet - Page 119

• Manufacturer Part Number: mpc8536e
• Description: Mpc8536e Powerquicctm Iii Integrated Processor Hardware Specifications
• Manufacturer: Freescale Semiconductor, Inc

The COP interface has a standard header, shown in
square-post, 0.100" centered header assembly (often called a Berg header). The connector typically has pin 14 removed as a
connector key.
The COP header adds many benefits such as breakpoints, watchpoints, register and memory examination/modification, and
other standard debugger features. An inexpensive option can be to leave the COP header unpopulated until needed.
There is no standardized way to number the COP header; consequently, many different pin numbers have been observed from
emulator vendors. Some are numbered top-to-bottom then left-to-right, while others use left-to-right then top-to-bottom, while
still others number the pins counter clockwise from pin 1 (as with an IC). Regardless of the numbering, the signal placement
recommended in
3.10.1
If the JTAG interface and COP header will not be used, Freescale recommends the following connections:
Freescale Semiconductor
•
•
TRST should be tied to HRESET through a 0 k Ω isolation resistor so that it is asserted when the system reset signal
(HRESET) is asserted, ensuring that the JTAG scan chain is initialized during the power-on reset flow. Freescale
recommends that the COP header be designed into the system as shown in
isolation resistor will allow future access to TRST in case a JTAG interface may need to be wired onto the system in
future debug situations.
No pull-up/pull-down is required for TDI, TMS, or TDO.
Termination of Unused Signals
Figure 79
MPC8536E PowerQUICC™ III Integrated Processor Hardware Specifications, Rev. 2
is common to all known emulators.
Figure
79, for connection to the target system, and is based on the 0.025"
Figure
78. If this is not possible, the
JTAG Configuration Signals
119