lan9210 Standard Microsystems Corp., lan9210 Datasheet - Page 46
lan9210
Manufacturer Part Number
lan9210
Description
Lan9210 Small Form Factor Single-chip Ethernet Controller With Hp Auto-mdix Support
Manufacturer
Standard Microsystems Corp.
Datasheet
1.LAN9210.pdf
(146 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
lan9210-ABZJ
Manufacturer:
Standard
Quantity:
2 500
- Current page: 46 of 146
- Download datasheet (2Mb)
Revision 2.3 (08-06-08)
3.10.3.2
3.11
PHY REG 0.15
SOURCE
RESET
PHY_RST
nRESET
SRST
Energy Detect Power-Down
This power-down mode is activated by setting the Phy register bit 17.13 to 1. Please refer to
5.5.8, "Mode Control/Status," on page 121
no energy is present on the line, the PHY is powered down, with the exception of the management
interface, the SQUELCH circuit and the ENERGYON logic. The ENERGYON logic is used to detect
the presence of valid energy from 100Base-TX, 10Base-T, or Auto-negotiation signals
In this mode, when the ENERGYON signal is low, the PHY is powered-down, and nothing is
transmitted. When energy is received - link pulses or packets - the ENERGYON signal goes high, and
the PHY powers-up. It automatically resets itself into the state it had prior to power-down, and asserts
the INT7.1 bit of the register defined in
ENERGYON interrupt is enabled, this event will cause an interrupt to the host. The first and possibly
the second packet to activate ENERGYON may be lost. When 17.13 is low, energy detect power-down
is disabled.
The LAN9210 has four reset sources:
Table 3.11
Note: For proper operation, the LAN9210 must be reset on power-up via the hardware reset input
Note 3.17 After any PHY reset, the application must wait until the “Link Status” bit in the PHY’s “Basic
Note 3.18 After a power-up, nRESET or SRST, the LAN9210 will automatically check for the
Note 3.19 HBI - “Host Bus Interface”, NASR - Not affected by software reset.
Detailed Reset Description
Hardware Reset Input Pin (nRESET)
Soft Reset (SRST)
PHY Soft Reset via PMT_CTRL bit 10 (PHY_RST)
PHY Soft Reset via PHY Basic Control Register (PHY REG 0.15)
PLL
(nRESET) or soft reset (SRST). To accomplish this, nRESET should be asserted for the
minimum period of 30ms at power-up. Alternatively, a soft reset may be performed following
power-up by setting the SRST bit of the HW_CFG register once the READY bit in the
PMT_CTRL register has been set. Refer to
and
X
shows the effect of the various reset sources on the LAN9210's circuitry.
Status Register” (PHY Reg. 1.2) is set before attempting to transmit or receive data.
presence of an external EEPROM. After any of these resets the application must verify
that the EPC Busy Bit (E2P_CMD, bit 31) is cleared before attempting to access the
EEPROM, or change the function of the GPO/GPIO signals, or before modifying the
ADDRH or ADDRL registers in the MAC.
Section 3.11.3, "Soft Reset (SRST)"
Note
HBI
3.19
X
X
Table 3.11 Reset Sources and Affected Circuitry
REGISTERS
Note 3.19
NASR
X
DATASHEET
MIL
X
X
Section 5.5.11, "Interrupt Source Flag," on page
for additional information on this register. In this mode when
46
MAC
for additional information.
X
X
Small Form Factor Single-Chip Ethernet Controller with HP Auto-MDIX Support
Section 3.11.1, "Hardware Reset Input (nRESET)"
Note 3.17
PHY
X
X
X
EEPROM MAC
RELOAD
Note 3.18
ADDR.
X
X
LATCHED
SMSC LAN9210
CONFIG.
STRAPS
124. If the
Datasheet
X
Section
Related parts for lan9210
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Interface, Integrated USB2.0 Compatible 3-Port Hub
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Lan91c100fd Rev. B Feast Fast Ethernet Controller With Full Duplex Capability
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Feast ? Ast Ethernet Controller
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Com20022i 10 Mbps Arcnet Ansi 878.1 Controller With 2k X 8 On-chip Ram
Manufacturer:
Standard Microsystems Corp.
Part Number:
Description:
Lpc47n207 Lpc Super I/o Irda Hot Docking Chip With Uart Data Brief
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Advanced I/o With X-bus Interface
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Fdc37m707 Enhanced Super I/o Controller With Wake-up Features
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Twenty Pin Uart Tpuart Corporation
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Enhanced Small Device Interface Controller
Manufacturer:
Standard Microsystems Corp.
Part Number:
Description:
Rpm-based Pwm Fan Controller
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Rpm-based Pwm Fan Controller
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Emc1001 1.5?c Smbus Temperature Sensor In Miniature Sot-23
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
1 Degree C Triple Temperature Sensor With Beta Compensation And Hotter Of Two Zones
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
1 Degree C Multiple Temperature Sensor With Beta Compensation And Hottest Of Thermal Zones
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
1 Degree C Triple Temperature Sensor With Resistance Error Correction & Hotter Of Two Zones
Manufacturer:
Standard Microsystems Corp.
Datasheet: