sak-c167cr-16rm ETC-unknow, sak-c167cr-16rm Datasheet - Page 24

• Manufacturer Part Number: sak-c167cr-16rm
• Description: Microcomputer Components 16-bit Cmos Single-chip Microcontrollers
• Manufacturer: ETC-unknow

C167CR-16RM
20Dec96@09:25h Intermediate Version
(CAPREL). Both timers can be clocked with an input clock which is derived from the CPU clock via
a programmable prescaler or with external signals. The count direction (up/down) for each timer is
programmable by software or may additionally be altered dynamically by an external signal on a
port pin (TxEUD). Concatenation of the timers is supported via the output toggle latch (T6OTL) of
timer T6, which changes its state on each timer overflow/underflow.
The state of this latch may be used to clock timer T5, and/or it may be output on a port pin (T6OUT).
The overflows/underflows of timer T6 can additionally be used to clock the CAPCOM timers T0 or
T1, and to cause a reload from the CAPREL register. The CAPREL register may capture the
contents of timer T5 based on an external signal transition on the corresponding port pin (CAPIN),
and timer T5 may optionally be cleared after the capture procedure. This allows absolute time
differences to be measured or pulse multiplication to be performed without software overhead.
The capture trigger (timer T5 to CAPREL) may also be generated upon transitions of GPT1 timer
T3’s inputs T3IN and/or T3EUD. This is especially advantageous when T3 operates in Incremental
Interface Mode.
Figure 6
Block Diagram of GPT1
Semiconductor Group
22