sak-c167cr-16rm ETC-unknow, sak-c167cr-16rm Datasheet - Page 44

• Manufacturer Part Number: sak-c167cr-16rm
• Description: Microcomputer Components 16-bit Cmos Single-chip Microcontrollers
• Manufacturer: ETC-unknow

Notes
1)
2)
3)
4)
5)
6)
7)
Semiconductor Group
C167CR-16RM
V
cases will be X000
During the sample time the input capacitance C
internal resistance of the analog source must allow the capacitance to reach its final voltage level within t
After the end of the sample time t
Values for the sample clock t
This parameter includes the sample time t
result register with the conversion result.
Values for the conversion clock t
This parameter depends on the ADC control logic. It is not a real maximum value, but rather a fixum.
TUE is tested at V
voltages within the defined voltage range.
The specified TUE is guaranteed only if an overload condition (see
not selected analog input pins and the absolute sum of input overload currents on all analog input pins does
not exceed 10 mA.
During the reset calibration sequence the maximum TUE may be 4 LSB.
During the conversion the ADC’s capacitance must be repeatedly charged or discharged. The internal
resistance of the reference voltage source must allow the capacitance to reach its respective voltage level
within t
Not 100% tested, guaranteed by design characterization.
AIN
may exceed V
CC
. The maximum internal resistance results from the programmed conversion timing.
AREF
H
AGND
or X3FF
=5.0V, V
20Dec96@09:25h Intermediate Version
or V
AREF
H
SC
, respectively.
AGND
depend on programming and can be taken from the table above.
S
CC
, changes of the analog input voltage have no effect on the conversion result.
up to the absolute maximum ratings. However, the conversion result in these
depend on programming and can be taken from the table above.
=0V, V
S
, the time for determining the digital result and the time to load the
CC
=4.9V. It is guaranteed by design characterization for all other
I
can be charged/discharged by the external source. The
42
I
OV
specification) occurs on maximum 2
S
.