lm21215a-1 National Semiconductor Corporation, lm21215a-1 Datasheet - Page 19
![no-image](/images/no-image-200.jpg)
lm21215a-1
Manufacturer Part Number
lm21215a-1
Description
15a High Efficiency Synchronous Buck Regulator With Frequency Synchronization
Manufacturer
National Semiconductor Corporation
Datasheet
1.LM21215A-1.pdf
(24 pages)
from the output capacitor ground, to the regulator GND pins,
to the inductor and then out to the load (see
minimize both loop areas, the input capacitor should be
placed as close as possible to the VIN pin. Grounding for both
the input and output capacitor should be close. Ideally, a
ground plane should be placed on the top layer that connects
the PGND pins, the exposed pad (EP) of the device, and the
ground connections of the input and output capacitors in a
small area near pins 10 and 11 of the device. The inductor
should be placed as close as possible to the SW pin and out-
put capacitor.
2. Minimize the copper area of the switch node. The six SW
pins should be routed on a single top plane to the pad of the
inductor. The inductor should be placed as close as possible
to the switch pins of the device with a wide trace to minimize
conductive losses. The inductor can be placed on the bottom
side of the PCB relative to the LM21215A-1, but care must be
taken to not allow any coupling of the magnetic field of the
inductor into the sensitive feedback or compensation traces.
3. Have a solid ground plane between PGND, the EP and the
input and output cap. ground connections. The ground con-
nections for the AGND, compensation, feedback, and soft-
start components should be physically isolated (located near
pins 1 and 20) from the power ground plane but a separate
ground connection is not necessary. If not properly handled,
poor grounding can result in degraded load regulation or er-
ratic switching behavior.
FIGURE 15. Schematic of LM21215A-1 Highlighting Layout Sensitive Nodes
Figure
15). To
19
4. Carefully route the connection from the VOUT signal to the
compensation network. This node is high impedance and can
be susceptible to noise coupling. The trace should be routed
away from the SW pin and inductor to avoid contaminating
the feedback signal with switch noise. Additionally,feedback
resistors R
minimize the trace length to FB between these resistors.
5. Make input and output bus connections as wide as possi-
ble. This reduces any voltage drops on the input or output of
the converter and can improve efficiency. Voltage accuracy
at the load is important so make sure feedback voltage sense
is made at the load. Doing so will correct for voltage drops at
the load and provide the best output accuracy.
6. Provide adequate device heatsinking. For most 15A de-
signs a four layer board is recommended. Use as many vias
as possible to connect the EP to the power plane heatsink.
The vias located underneath the EP will wick solder into them
if they are not filled. Complete solder coverage of the EP to
the board is required to achieve the θ
the previous section. Either an adequate amount of solder
must be applied to the EP pad to fill the vias, or the vias must
be filled during manufacturing. See the Thermal Considera-
tions section to ensure enough copper heatsinking area is
used to keep the junction temperature below 125°C.
FB1
and R
FB2
should be located near the device to
30152148
JA
values described in
www.national.com