w25x32a Winbond Electronics Corp America, w25x32a Datasheet - Page 11

• Manufacturer Part Number: w25x32a
• Description: 32m-bit Serial Flash Memory With 4kb Sectors And Dual Output Spi
• Manufacturer: Winbond Electronics Corp America

10.2 WRITE PROTECTION
Applications that use non-volatile memory must take into consideration the possibility of noise and other
adverse system conditions that may compromise data integrity. To address this concern the W25X32A
provides several means to protect data from inadvertent writes.
10.2.1 Write Protect Features
•
•
•
•
•
•
•
Upon power-up or at power-down the W25X32A will maintain a reset condition while VCC is below the
threshold value of V
operations are disabled and no instructions are recognized. During power-up and after the VCC voltage
exceeds V
includes the Write Enable, Page Program, Sector Erase, Block Erase, Chip Erase and the Write Status
Register instructions. Note that the chip select pin (/CS) must track the VCC supply level at power-up until
the VCC-min level and t
accomplish this.
After power-up the device is automatically placed in a write-disabled state with the Status Register Write
Enable Latch (WEL) set to a 0. A Write Enable instruction must be issued before a Page Program, Sector
Erase, Chip Erase or Write Status Register instruction will be accepted. After completing a program,
erase or write instruction the Write Enable Latch (WEL) is automatically cleared to a write-disabled state
of 0.
Software controlled write protection is facilitated using the Write Status Register instruction and setting
the Status Register Protect (SRP) and Block Protect (TB, BP2, BP1, and BP0) bits. These Status
Register bits allow a portion or all of the memory to be configured as read only. Used in conjunction with
the Write Protect (/WP) pin, changes to the Status Register can be enabled or disabled under hardware
control. See Status Register for further information.
Additionally, the Power-down instruction offers an extra level of write protection as all instructions are
ignored except for the Release Power-down instruction.
Device resets when VCC is below threshold.
Time delay write disable after Power-up.
Write enable/disable instructions.
Automatic write disable after program and erase.
Software write protection using Status Register.
Hardware write protection using Status Register and /WP pin.
Write Protection using Power-down instruction.
WI
, all program and erase related instructions are further disabled for a time delay of t
WI
, (See Power-up Timing and Voltage Levels and Figure 20). While reset, all
VSL
time delay is reached. If needed a pull-up resister on /CS can be used to
- 11 -
Publication Release Date: August 24, 2008
Preliminary - Revision A
W25X32A
PUW
. This