m58bw016 Numonyx, m58bw016 Datasheet - Page 24

no-image

m58bw016

Manufacturer Part Number
m58bw016
Description
16 Mbit 512 Kbit X 32, Boot Block, Burst 3 V Supply Flash Memories
Manufacturer
Numonyx
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
m58bw016BB80T3
Manufacturer:
ST
Quantity:
715
Part Number:
m58bw016BB80T3
Manufacturer:
ST
0
Part Number:
m58bw016BB80T3ES
Manufacturer:
ST
0
Part Number:
m58bw016BB80T3F
Manufacturer:
ST
Quantity:
490
Part Number:
m58bw016BB80T3F
Manufacturer:
ST
0
Part Number:
m58bw016BB80T3PT
Manufacturer:
NSC
Quantity:
2 808
Part Number:
m58bw016DB7
Manufacturer:
ST
0
Part Number:
m58bw016DB70T3
Manufacturer:
ST
Quantity:
6 975
Part Number:
m58bw016DB70T3
Manufacturer:
ST
0
Part Number:
m58bw016DB70T3F
Manufacturer:
ST
Quantity:
6 793
Part Number:
m58bw016DB70T3F
Manufacturer:
ST
Quantity:
20 000
Part Number:
m58bw016DB70T3NS
Manufacturer:
ST
Quantity:
17 246
Part Number:
m58bw016DB7T3TNS
Manufacturer:
ST
Quantity:
20 000
Bus operations
3.3.6
3.3.7
3.3.8
24/70
Valid clock edge bit (M6)
The valid clock edge bit, M6, is used to configure the active edge of the Clock, K, during
synchronous burst read operations. When the valid clock edge bit is ’0’ the falling edge of
the clock is the active edge; when the valid clock edge bit is ’1’ the rising edge of the clock is
active.
Wrap burst bit (M3)
The burst reads can be confined inside the 4 or 8 double-word boundary (wrap) or
overcome the boundary (no wrap). The wrap burst bit is used to select between wrap and no
wrap. When the wrap burst bit is set to ‘0’ the burst read wraps; when it is set to ‘1’ the burst
read does not wrap.
Burst length bit (M2-M0)
The burst length bits set the maximum number of double-words that can be output during a
synchronous burst read operation before the address wraps. Burst lengths of 4 or 8 are
available for both the sequential and interleaved burst types, and a continuous burst is
available for the sequential type.
Table 7: Burst configuration register
the memory accepts;
from a given starting address for each length.
If either a continuous or a no wrap burst read has been initiated the device will output data
synchronously. Depending on the starting address, the device activates the valid data ready
output to indicate that a delay is necessary before the data is output. If the starting address
is aligned to an 8 double-word boundary, the continuous burst mode will run without
activating the valid data ready output. If the starting address is not aligned to an 8 double-
word boundary, valid data ready is activated to indicate that the device needs an internal
delay to read the successive words in the array.
M10, M5 and M4 are reserved for future use.
Table 8: Burst type
M58BW016DT, M58BW016DB, M58BW016FT, M58BW016FB
gives the valid combinations of the burst length bits that
definition, gives the sequence of addresses output

Related parts for m58bw016