W83627G Winbond Electronics Corp America, W83627G Datasheet - Page 82

no-image

W83627G

Manufacturer Part Number
W83627G
Description
LPC Interface I/O plus Game Port, MIDI Port, Pb-free package
Manufacturer
Winbond Electronics Corp America
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
W83627G-AW
Manufacturer:
Nuvoton Technology Corporation of America
Quantity:
10 000
Part Number:
W83627G-AW
Manufacturer:
WINBOND/华邦
Quantity:
20 000
Part Number:
W83627GF-AW
Manufacturer:
Winbond
Quantity:
176
Part Number:
W83627GF-AW
Manufacturer:
SEK
Quantity:
85
Part Number:
W83627GF-AW
Manufacturer:
WB
Quantity:
1 000
Part Number:
W83627GF-AW
Manufacturer:
WB
Quantity:
1 000
Part Number:
W83627GF-AW
Manufacturer:
WINBOND/华邦
Quantity:
20 000
9. CONFIGURATION REGISTER
9.1
The W83627HF/F uses Compatible PNP protocol to access configuration registers for setting up dif-
ferent types of configurations. In W83627HF/F, there are eleven Logical Devices(from Logical De-
vice 0 to Logical Device B with the exception of logical device 4 for backward compatibility)which
correspond to eleven individual functions: FDC(logical device 0), PRT(logical device 1),
UART1 (logical device 2), UART2(logical device 3), KBC(logical device 5), CIR(Consumer
IR, logical device 6), GPIO1(logical device 7), GPIO2(logical device 8), GPIO3(logical device
9), ACPI (logical device A), and hardware monitor (logical device B). Each Logical Device has
its own configuration registers (above CR30). Host can access those registers by writing an appro-
priate logical device number into logical device select register at CR7.
9.1.1
9.1.1.1
In Compatible PnP, there are two ways to enter Extended Function and read or write the configuration
registers. HEFRAS(CR26 bit 6)can be used to select one out of these two methods of entering the
Extended Function mode as follows:
After Power-on reset, the value on RTSA (pin 51)is latched by HEFRAS of CR26. In Compatible
PnP, a specific value(87h)must be written twice to the Extended Functions Enable Register(I/O
port address 2Eh or 4Eh). Secondly, an index value (02h, 07h ~ FFh)must be written to the Ex-
tended Functions Index Register(I/O port address 2Eh or 4Eh same as Extended Functions Enable
Register)to identify which configuration register is to be accessed. The designer can then access
the desired configuration register through the Extended Functions Data Register(I/O port address
2Fh or 4Fh).
After programming of the configuration register is finished, an additional value(AAh)should be writ-
ten to EFERs to exit the Extended Function mode to prevent unintentional access to those configura-
Compatible PnP
Plug and Play Configuration
Extended Function Registers
HEFRAS
0
1
write 87h to the location 2Eh twice
write 87h to the location 4Eh twice
- 78 -
ADDRESS AND VALUE
W83627HF/ F/ HG/ G

Related parts for W83627G