cop87l84bc National Semiconductor Corporation, cop87l84bc Datasheet - Page 20

• Manufacturer Part Number: cop87l84bc
• Description: 8-bit Cmos Otp Microcontrollers With 16k Memory, Comparators, And Can Interface
• Manufacturer: National Semiconductor Corporation

www.national.com
CAN Interface Block
Fully automatic transmission on error is supported for mes-
sages not longer than two bytes. Messages which are longer
than two bytes have to be processed by software.
The interface is compatible with CAN Specification 2.0 part
B, without the capability to receive/transmit extended
frames. Extended frames on the bus are checked and ac-
knowledged according to the CAN specification.
The maximum bus speed achievable with the CAN interface
is a function of crystal frequency, message length and soft-
Functional Block Description of
the CAN Interface
Interface Management Logic (IML)
The IML executes the CPU’s transmission and reception
commands and controls the data transfer between CPU,
Rx/Tx and CAN registers. It provides the CAN Interface with
Rx/Tx data from the memory mapped Register Block. It also
sets and resets the CAN status information and generates
interrupts to the CPU.
(Continued)
FIGURE 17. CAN Interface Block Diagram
20
ware overhead. The device can support a bus speed of up to
1 Mbit/s with a 10 MHz oscillator and 2 byte messages. The
1 Mbit/s bus speed refers to the rate at which protocol and
data bits are transferred on the bus. Longer messages re-
quire slower bus speeds due to the time required for soft-
ware intervention between data bytes. The device will sup-
port a maximum of 125k bit/s with eight byte messages and
a 10 MHz oscillator.
Bit Stream Processor (BSP)
The BSP is a sequencer controlling the data stream between
The Interface Management Logic (parallel data) and the bus
line (serial data). It controls the transceive logic with regard
to reception and arbitration, and creates error signals ac-
cording to the bus specification
DS101137-49