xrt75r03 Exar Corporation, xrt75r03 Datasheet - Page 8

• Manufacturer Part Number: xrt75r03
• Description: Xrt75r03 -multi-channel Line Interface Unit Liu Family Desynchronizer And Jitter Attenuator With R3 Technologytm
• Manufacturer: Exar Corporation

XRT75R03
REV. 1.0.8
SYSTEM-SIDE TRANSMIT INPUT AND TRANSMIT CONTROL PINS
P
34
25
33
24
IN
3
2
#
TPDATA_0/TxDATA_0
TPDATA_1/TxDATA_1
TPDATA_2/TxDATA_2
S
IGNAL
TNData_0
TNData_1
TNData_2
THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
N
AME
T
YPE
I
I
Transmit Positive Data Input - Channel 0
Transmit Positive Data Input - Channel 1
Transmit Positive Data Input - Channel 2
Transmit Positive Data/Data Input - Channel n:
The function of these input pins depends upon whether the corresponding
channel has been configured to operate in the Single-Rail or Dual-Rail
Mode.
Single Rail Mode - Transmit Data Input - Channel n:
If the Channel has been configured to operate in the Single-Rail Mode,
then all transmit output data will be serially applied to this input pin. This
signal will latched into the Transmit Section circuitry upon either the rising
or falling edge of the TxCLK_n signal, depending upon user configuration.
In the Single-Rail Mode, the Transmit Section of the LIU IC will then encode
this data into either the B3ZS line code (for DS3 and STS-1 applications) or
the HDB3 line code (for E3 applications).
Dual Rail Mode - Transmit Positive Data Input - Channel n:
If the Channel has been configured to operate in the Dual-Rail Mode, then
the user should apply a pulse to this input pin, anytime the Transmit Sec-
tion of the LIU IC is suppose to generate and transmit a positive-polarity
pulse onto the line. This signal will be latched into the Transmit Section cir-
cuitry upon either the rising or falling edge of the TxCLK_n signal, depend-
ing upon user configuration.
In the Dual-Rail Mode, the Transmit Section of the LIU IC will NOT encode
this data into either the B3ZS or HDB3 line codes. If the user configures
the LIU IC to operate in the Dual-Rail Mode, then B3ZS/HDB3 encoding
must have already been done prior to providing the transmit output data to
this input pin.
Transmit Negative Data Input - Channel 0:
Transmit Negative Data Input - Channel 1:
Transmit Negative Data Input - Channel 2:
If a Channel has been configured to operate in the Dual-Rail Mode, then
the user should apply a pulse to this input pin anytime the Transmit Section
of the LIU IC is suppose to generate and transmit a negative-polarity pulse
onto the line. This signal will be latched into the Transmit Section circuitry
upon either the rising or falling edge of the TxCLK_n signal, depending
upon user configuration.
N
OTE
: If the Channel has been configured operate in the Single-Rail Mode,
then this input pin has no function, and should be tied to GND.
5
D
ESCRIPTION
:
:
:
xr
xr
xr
xr