wm8762ged-v Wolfson Microelectronics plc, wm8762ged-v Datasheet - Page 14

• Manufacturer Part Number: wm8762ged-v
• Description: 24-bit 192khz Stereo Dac
• Manufacturer: Wolfson Microelectronics plc

WM8762
RECOMMENDED ANALOGUE LOW PASS FILTER (OPTIONAL)
Figure 14 Recommended Low Pass Filter (Optional)
PCB LAYOUT RECOMMENDATIONS
w
+
10uF
47k
1.8k
Ω
Ω
An external low pass filter is recommended (see Figure 20) if the device is driving a wideband
amplifier. In some applications, a passive RC filter may be adequate.
Care should be taken in the layout of the PCB that the WM8726 is to be mounted to. The
following notes will help in this respect:
1.
2.
3.
An evaluation board is available for the WM8726 that demonstrates the above techniques and
the excellent performance achievable from the device. This can be ordered or the User manual
downloaded from the Wolfson web site at
1.0nF
4.7k
7.5K
The VDD supply to the device should be as noise free as possible. This can be
accomplished to a large degree with a 10uF bulk capacitor placed locally to the device and a
0.1uF high frequency decoupling capacitor placed as close to the VDD pin as possible. It is
best to place the 0.1uF capacitor directly between the VDD and GND pins of the device on
the same layer to minimize track inductance and thus improve device decoupling
effectiveness.
Separate analogue and digital track routing from each other. The device is split into
analogue (pins 5 – 9) and digital (pins 1 – 4 and pins 10 – 14) sections that allow the routing
of these signals to be easily separated. By physically separating analogue and digital
signals, crosstalk from the PCB can be minimized.
Use an unbroken solid GND plane.
advisable to have either a GND plane layer on a multilayer PCB or to dedicate one side of a
2 layer PCB to be a GND plane. For double sided implementations it is best to route as
many signals as possible on the device mounted side of the board, with the opposite side
acting as a GND plane. The use of a GND plane greatly reduces any electrical emissions
from the PCB and minimizes crosstalk between signals.
Ω
Ω
4.7k
Ω
680pF
_
+
+VS
-VS
51
www.wolfsonmicro.com
Ω
To achieve best performance from the device, it is
PD, Rev 4.4, January 2009
Production Data
14