wm9715l Wolfson Microelectronics plc, wm9715l Datasheet - Page 39
wm9715l
Manufacturer Part Number
wm9715l
Description
Ac?97 Audio And Touchpanel Codec
Manufacturer
Wolfson Microelectronics plc
Datasheet
1.WM9715L.pdf
(77 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
wm9715lGEFL
Manufacturer:
WOLFSON
Quantity:
20 000
Company:
Part Number:
wm9715lGEFL/RV
Manufacturer:
WOLFSON
Quantity:
358
Part Number:
wm9715lGEFL/RV
Manufacturer:
WOLFSON
Quantity:
20 000
Part Number:
wm9715lGEFL/V
Manufacturer:
WOLFSON
Quantity:
20 000
Production Data
w
The principle of operation is illustrated below (Note: the illustrations assume that the top plate is used
for X and the bottom plate for Y measurements, although the reverse is also possible).
Figure 6 X Co-ordinate Measurement on 4-wire Touchpanel
For an X co-ordinate measurement, the X+ pin is internally switched to VDD and X- to GND. The X
plate becomes a potential divider, and the voltage at the point of contact is proportional to its X co-
ordinate. This voltage is measured on the Y+ and Y- pins, which carry no current (hence there is no
voltage drop in R
Due to the ratiometric measurement method, the supply voltage does not affect measurement
accuracy. The voltage references VREF+ and VREF- are taken from after the matrix switches, so
that any voltage drop in these switches has no effect on the ADC measurement.
Figure 7 Y Co-ordinate Measurement on 4-wire Touchpanel
Y co-ordinate measurements are similar to X co-ordinate measurements, with the X and Y plates
interchanged.
Figure 8 Pen Down Detection on 4-wire Touchpanel
Pen down detection uses a zero power comparator (effectively a CMOS logic gate) with an internal,
programmable pull-up resistor R
touchpanel less sensitive to touch, while lowering R
Y+
or R
Y-
).
PU
that controls pen-down sensitivity. Increasing R
PU
makes it more sensitive.
PD Rev 4.0 December 2007
WM9715L
PU
makes the
39