h3ds-x Omron Corporation, h3ds-x Datasheet - Page 34

• Manufacturer Part Number: h3ds-x
• Description: Solid-state Timer
• Manufacturer: Omron Corporation

■ Wiring
Use wires of the applicable sizes specified above. The length of the exposed conductor should be 6 to 7 mm.
Use the following wiring procedure.
1. Insert the specified screwdriver into the release hole located beside the wire connection hole where the wire is to be inserted.
2. Insert the exposed conductor into the wire connection hole.
3. Pull out the screwdriver.
Wire
connection
holes
Release
holes
Fig. 2 Wire Connection Holes and Release Holes
Fig. 1 Exposed Conductor Length
Fig. 3 Section A-A of Fig. 2
http://www.ia.omron.com/
6 to 7 mm
Wire connection hole
Release hole
A
A
Insert
Insert
Screwdriver
Pull out
Insert
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
H3DS-@LC
34