txc-04246 TranSwitch Corporation, txc-04246 Datasheet

no-image

txc-04246

Manufacturer Part Number
txc-04246
Description
Oc-3 Ethemet Over Sonet/sdh Mapper
Manufacturer
TranSwitch Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
txc-04246AIBG
Manufacturer:
PHILIPS
Quantity:
101
Part Number:
txc-04246AIBG
Manufacturer:
TRANSWITCH
Quantity:
11
Part Number:
txc-04246AIBG B
Manufacturer:
TRANSWITCH
Quantity:
9
Part Number:
txc-04246AIBG B
Manufacturer:
TRANSWIT
Quantity:
453
Part Number:
txc-04246ARBG
Manufacturer:
TRANSWITCH
Quantity:
5
U.S. and/or foreign patents issued or pending
Copyright © 2004 TranSwitch Corporation
EtherMap, PHAST, TEMx28, TranSwitch and TXC
are registered trademarks of TranSwitch Corporation
• Eight 10/100 Mbit/s Ethernet ports, each using a SMII
• Single 1000 Mbit/s Ethernet port, using a parallel GMII
• Ethernet Jumbo Frame support, all modes
• Ethernet Management interface for control
• Low latency throughput performance
• 64 ms differential delay compensation
• Configurable transmit and receive buffers up to 512 kbytes
• Provides IEEE 802.3 Half Duplex mode on 10/100 Mbit/s
• Provides IEEE 802.3 Management Statistics (RMON)
• Ethernet frame encapsulation/decapsulation protocols:
• Performs mapping/demapping of encapsulated Ethernet
• Performs mapping/demapping of encapsulated Ethernet
• On-chip LCAS processing (ITU-T G.7042) for low and high
• Glueless interface to external 64/128/256 Mbit SDRAM
• Low Order POH and Pointer processing for 84/63 VT1.5/
• High Order POH processing for STS-1 SPE/VC-3/STS-3c
• Byte-wide 19 MHz parallel Add and Drop Telecom Bus
• Per-port Ethernet side and SONET/SDH system side
• 16-bit wide microprocessor interface, selectable between
• Boundary scan (IEEE 1149.1 standard)
• + 3.3V and +1.8V power supplies, 5V tolerant I/O leads
• 400-lead plastic ball grid array package
• Device Driver
FEATURES
• ITU-T G.7041, Generic Framing Procedure (GFP)
• ITU-T X.86/X.85, Link Access Procedure SDH (LAPS)
• ITU-T Q.922, Link Access Procedure Frame Mode (LAPF)
• RFC1662/3518, PPP Bridging Control Protocol (BCP)
interface
interface (lead shared with SMII interfaces)
and Full Duplex mode on 10/100/1000 Mbit/s Ethernet ports
frames into/from low order (VT1.5 SPE/VT2 SPE/VC-11/
VC-12) and high order (STS-1 SPE/VC-3) virtually
concatenated payloads
frames into/from a single contiguous concatenated (STS-3c-
SPE/VC-4) payload or a single Low/High order (VT1.5/VT2/
VC-11/VC-12/STS-1/VC-3) payload
order virtual concatenated payloads
VT2/TU-11/TU-12 and 3 TU-3
SPE/VC-4
interfaces
loopback for system level diagnostics
Motorola or Intel
(PBGA, 27 mm x 27 mm)
TELECOM BUS SIDE
TranSwitch Corporation
DROP Bus
ADD Bus
Tel: 203-929-8810
+3.3V
+1.8V
Microprocessor
Interface
3 Enterprise Drive
HO/LO
RING
Ports
Fax: 203-926-9453
EtherMap -3 Pt
SONET/SDH Mapper
OC-3 Ethernet over
Interface
SDRAM
HO/LO
POH
Ports
TXC-04246
DESCRIPTION
APPLICATIONS
The EtherMap -3 Pt (Platinum) is a highly integrated EoS device that
provides for mapping of 10/100/1000 Mbit/s Ethernet into SONET/SDH
STS-3/STM-1 Transport payloads with extremely low latency throughput.
The device supports connection for up to eight 10/100 Mbit/s Ethernet
ports, using SMII interfaces, or a single 1000 Mbit/s Ethernet port, using a
GMII interface. Ethernet frames are encapsulated using either GFP , LAPS,
LAPF or PPP/BCP protocol. The encapsulated Ethernet frames are then
mapped into either virtually concatenated low or high order payloads, such
as VT1.5 SPE/VT2 SPE/VC-11/VC-12/STS-1 SPE/VC-3, or into
contiguously concatenated payloads such as STS-3c SPE/VC-4. Low and
high order SONET/SDH POH generation and processing/termination is
performed. A Telecom Bus provides the SONET/SDH interface.
In addition to support for full-rate Ethernet transfer, over-subscribed
Ethernet transfers are also supported using back pressure mechanisms
(half and full duplex flow control) in order to prevent frame loss.
Configurable external SDRAM is used for buffering Ethernet frames to
support bandwidth oversubscription, highly bursty traffic and flow control
operation. Buffers are used as well for receive SONET/SDH container
alignment and differential delay compensation of low and high order
virtually concatenated payloads.
For both low and high order virtually concatenated payloads, optional on-
chip standards based LCAS processing is provided to allow hitless
dynamic bandwidth adjustments.
A powerful hardware and RTOS independent EtherMap family device
driver provides full access to all the features of the device through APIs. It
utilizes matched get/set functions and can be easily ported.
• SONET/SDH Add/Drop and Terminal Multiplexers
• Multi-Service Access Platforms (MSAP)
• Compact Access or CPE Platforms
• IP DSLAMS
• Wireless Backhaul Electronics (RNC/BSC)
• Latency Sensitive Transport (FTP)
Controls
Boundary
Scan
OC-3 Ethernet over SONET/SDH Mapper
Shelton, Connecticut 06484
CLOCKS
(SONET/SDH Ref,
System, One Sec.)
Management
Ethernet
Interface
www.transwitch.com
EtherMap -3 Pt Device
PRODUCT INFORMATION
ETHERNET LINE SIDE
10/100 Mbit/s SMII (Port 8)
10/100 Mbit/s SMII (Port 1)
/ 1000 Mbit/s GMII
TXC-04246-MC, Ed. 1
Document Number:
USA
TXC-04246
October 2004

Related parts for txc-04246

txc-04246 Summary of contents

Page 1

... Shelton, Connecticut 06484 • • • Fax: 203-926-9453 • www.transwitch.com EtherMap -3 Pt Device TXC-04246 PRODUCT INFORMATION ETHERNET LINE SIDE 10/100 Mbit/s SMII (Port 1) / 1000 Mbit/s GMII • • • • 10/100 Mbit/s SMII (Port 8) Document Number: TXC-04246-MC, Ed. 1 October 2004 USA • ...

Page 2

... GMII interface SDRAM 3 Enterprise Drive • Shelton, Connecticut 06484 Fax: 203-926-9453 www.transwitch.com • • EtherMap-3 Pt, TXC-04246 10/100 Mbit/s SMII interfaces Ethernet Switch x16 (24 Ports 28xDS1 / 21xE1 Gigabit Ethernet 1000 Mbit/s PHY Line Document Number: TXC-04246-MC, Ed. 1 October 2004 • USA ...

Related keywords