sx1231h Semtech Corporation, sx1231h Datasheet - Page 40

• Manufacturer Part Number: sx1231h
• Description: Low Power Integrated Uhf Transceiver With On-chip +20dbm Pa
• Manufacturer: Semtech Corporation

Notes - the accuracy of the typical timings given in Table 17 will depend in the RC oscillator calibration
4.3.2. Criteria
The criteria taken for detecting a wanted signal and hence deciding to maintain the receiver on is defined by ListenCriteria
in RegListen1.
Table 18 Signal Acceptance Criteria in Listen Mode
4.3.3. End of Cycle Actions
The action taken after detection of a packet, is defined by ListenEnd in RegListen3, as described in the table below.
Table 19 End of Listen Cycle Actions
Rev 1 - Oct 2011
ADVANCED COMMUNICATIONS & SENSING
- RC oscillator calibration is required, and must be performed at power up. See section 4.3.5 for details
ListenEnd
00
01
10
mode defined by Mode. Listen mode stops and must be disabled.
resumes in Idle state. FIFO content is lost at next Rx wakeup.
Chip stays in Rx mode. Listen mode stops and must be disabled.
Chip stays in Rx mode until PayloadReady or Timeout interrupt occurs. It then goes to the
Chip stays in Rx mode until PayloadReady or Timeout interrupt occurs. Listen mode then
ListenCriteria
0
1
Input Signal Power
>= RssiThreshold
Required
Required
Page 40
Description
SyncAddressMatch
Not Required
Required
SX1231H
DATASHEET
www.semtech.com