sx1231h Semtech Corporation, sx1231h Datasheet - Page 49

• Manufacturer Part Number: sx1231h
• Description: Low Power Integrated Uhf Transceiver With On-chip +20dbm Pa
• Manufacturer: Semtech Corporation

5.4. Continuous Mode
5.4.1. General Description
As illustrated in Figure 29, in Continuous mode the NRZ data to (from) the (de)modulator is directly accessed by the uC on
the bidirectional DIO2/DATA pin. The FIFO and packet handler are thus inactive.
5.4.2. Tx Processing
In Tx mode, a synchronous data clock for an external uC is provided on DIO1/DCLK pin. Clock timing with respect to the
data is illustrated in Figure 30. DATA is internally sampled on the rising edge of DCLK so the uC can change logic state
anytime outside the grayed out setup/hold zone.
Note
Rev 1 - Oct 2011
ADVANCED COMMUNICATIONS & SENSING
Data
DCLK
DATA
(NRZ)
the use of DCLK is required when the modulation shaping is enabled (see section 3.3.5).
Tx/Rx
Rx
SYNC
RECOG.
Figure 29. Continuous Mode Conceptual View
Figure 30. Tx Processing in Continuous Mode
T_DATA
T_DATA
CONTROL
Page 49
SPI
SX1231H
DATASHEET
MISO
www.semtech.com
SCK
MOSI
NSS
DIO0
DIO2/DATA
DIO3
DIO4
DIO5
DIO1/DCLK