znbg2001 Zetex Semiconductors plc., znbg2001 Datasheet - Page 5
![no-image](/images/no-image-200.jpg)
znbg2001
Manufacturer Part Number
znbg2001
Description
Fet Bias Controller
Manufacturer
Zetex Semiconductors plc.
Datasheet
1.ZNBG2001.pdf
(7 pages)
TYPICAL APPLICATION CIRCUIT
INFORMATION
The above is a partial application circuit for the ZNBG
series showing all external components required for
appropriate biasing. The bias circuits are
unconditionally stable over the full temperature
range with the associated FETs and gate and drain
capacitors in circuit.
Capacitors C
supply and substrate generator noise is not allowed
to affect other external circuits which may be
sensitive to RF interference. They also serve to
suppress any potential RF feedthrough between
stages via the ZNBG device. These capacitors are
required for all stages used. Values of 10nF and 4.7nF
respectively are recommended however this is
design dependent and any value between 1nF and
100nF could be used.
The capacitors C
the ZNBGs negative supply generator. The negative
bias voltage is generated on-chip using an internal
oscillator. The required value of capacitors C
C
supply of approximately -3 volts. Although this
generator is intended purely to bias the external
FETs, it can be used to power other external circuits
via the C
ISSUE 1 - AUGUST 2001
SUB
is 47nF. This generator produces a low current
SUB
D
pin.
and C
NB
and C
G
ensure that residual power
SUB
are an integral part of
8
NB
and
5
Resistor R
external FETs are operated. If any bias control circuit
is not required, its related drain and gate connections
may be left open circuit without affecting the
operation of the remaining bias circuits. If all FETs
associated with a current setting resistor are omitted,
the particular R
supply current can be reduced, if required, by using a
high value R
The ZNBG devices have been designed to protect the
external FETs from adverse operating conditions.
With a JFET connected to any bias circuit, the gate
output voltage of the bias circuit can not exceed the
range -3.5V to 0.7V, under any conditions including
powerup and powerdown transients. Should the
negative bias generator be shorted or overloaded so
that the drain current of the external FETs can no
longer be controlled, the drain supply to FETs is shut
down to avoid damage to the FETs by excessive
drain current.
The following diagram show the ZNBG2000/1 in
typical LNB applications.
CAL1
CAL
sets the drain current at which all
CAL
resistor (e.g. 470k).
should still be included. The
ZNBG2000
ZNBG2001
16k
APPLICATIONS