4455-LED-434-PER SILABS [Silicon Laboratories], 4455-LED-434-PER Datasheet - Page 9

• Manufacturer Part Number: 4455-LED-434-PER
• Manufacturer: SILABS [Silicon Laboratories]

Options:
2.4.1.6. Frequency Configuration Menu
The user can set the communication frequency in this menu state.
State Display:
Set the Configuration:
Options:
2.4.1.7. Data Rate Configuration Menu
The user can set the communication data rate in this menu state.
State Display:
Set the Configuration:
Options:









PB1:
LED2 blinks
Set the frequency number on the switches by their frequency number:
In case of wrong selection is set or the selected frequency number is not supported (e.g., no custom
frequency is stored) the default frequency of the used frequency band will be selected.
PB2:
LED3 blinks
Set the data rate number on the switches by their frequency number:
In case of wrong selection is set or the selected data rate number is not supported (e.g. no custom data
rate is stored) the default data rate will be selected.
PB3:


















Stores new settings
Result: blinks all LED once
Next state: Ready state
Custom: SW1–SW4 are on
Freq. num. 1: SW1 is on, all others are off
Freq. num. 2: SW2 is on, all others are off
Freq. num. 3: SW3 is on, all others are off
Freq. num. 4: SW4 is on, all others are off
Stores new settings
Results:
Next State: Ready state
Custom: SW1 – SW4 are on
Data rate num. 1: SW1 is on, all others are off
Data rate num. 2: SW2 is on, all others are off
Data rate num. 3: SW3 is on, all others are off
Stores new settings
Results:
Next state: Ready state
i. Blinks all LEDs once if selection is OK.
ii. Blinks LED4 and beeps buzzer once if the parameter had to be set to default because of an
i. blinks all LED once if selection is OK
ii. blinks LED4 and beeps buzzer once if parameter had to be set to default because of not
unsupported selection.
supported selection
Rev. 0.1
Si4455-2WayLink-DEMO
9