w89c926 Winbond Electronics Corp America, w89c926 Datasheet - Page 17
w89c926
Manufacturer Part Number
w89c926
Description
Pcmcia Ethernet Network Twisted Pair Interface Controller
Manufacturer
Winbond Electronics Corp America
Datasheet
1.W89C926.pdf
(48 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
w89c926F
Manufacturer:
XILINX
Quantity:
2
CFB (Configuration Register B), continued
Special Control Register Set
These registers are used for special checking or EEPROM access control.
Signature Register (SR)
A signature register is used for identification so that the software driver can easily distinguish between
different chips. The content can be read out in toggled order as follows:
Access Address: AMBase + 00FF4H
Access Type: Attribute Memory Read
EEPROM Access Register (EEAR)
This register is located on page 3 and is used for EEPROM read/write access control. It is inhibited
when EECS/FCS is pulled high.
Access Address: IOBase + 02H
Access Type: I/O Read/Write
(2N)th time:
(2N-1)th time:
BIT
2
3
4
5
6
7
SRAMSEL
IO16CON
SYMBOL
LNKSTS
LNKEN
FWEN
-
10001000
00000000
MSB
LSB
Link Enable
Writing a "1" to this bit will disable the link pulse generation, auto media-
switching function, and link integrity check function. Writing a "0" to this bit
will enable these functions.
Link Status
This bit indicates the present link status. It is high if the PENTIC+ is in TPI
mode, the link checking is enabled, and the link integrity is good or if the
link checking is disabled; otherwise, it is low.
IOIS16 Timing Control.
If this bit is set high, the IOIS16 signal will decode CE1,2 ; otherwise,
IOIS16 is decoded according to HA and REG (default).
Flash Write Enable.
The default setting for the flash memory is write-protected. If FWEN = 1,
the PENTIC+ allows the flash to be written to. The write command and
chip select signal is prohibited if FWEN = 0.
SRAM Speed Select.
If SRAMSEL = 1, the SRAM-15 is selected. Otherwise, SRAM-70 is used.
The default is SRAM-70.
Reserved.
where N = 1, 2, ... (after H/W reset)
- 17 -
DESCRIPTION
Publication Release Date: January 1996
W89C926 PENTIC+
Revision A1