evqp6yb55 Panasonic Corporation of North America, evqp6yb55 Datasheet - Page 6

• Manufacturer Part Number: evqp6yb55
• Description: Light Touch Switch
• Manufacturer: Panasonic Corporation of North America

Classification
6. Prohibitions and precaution for handling
Part Name
6.2 Mounting condition
6.3 Handing after soldering
6.1 Reflow soldering condition
【Restrictions】
3) Please do not load extra heat and pressure during re-work process by iron soldering.
4) Do not put any object such as a weight etc. on the operating knob during soldering.
5) In case that this switch is mounted on FPC board like film,we expect the board shall be
1) As this product is thin and small type,when the mechanical chuck is to be used at
1) Do not load extra pressure on the switch after soldering.
2) Do not make a extra bending condition of P.C.bd like below figure.
3) In case of using a masking tape on a P.C.db, do not put it on the switch.
1) Therefore,be sure to perform soldering by following reflow temperature profile.
2) Do not put this switch into the washing process after soldering because this switch does
2) Three times max.It is possible to conduct reflow soldering with switch side down after at
1) Wave soldering(by solder bath dwelling)is prohibited because this switch does not have a
In order to prevent accidents or performance deteriorations in use of the product,observe
the following restrictions and pay attentions to the following items.
Example,under the condition like stack of the P.C.bd on the switch.
In the process of re-work the power of iron solder should be less than 60 watts and
soldering condition should be as follows,
Temperature : 350 ℃ max., Period : 3 seconds max. Time : 1 time only.
not have a capability of washing even water.
tough by putting additional board for reinforcement on the reverse side.
We are concerned that the switch may be damaged due to an extra stress with multiple
undulations from FPC board after soldering.
automatic mounting,it is subject to be deformed, Please mount after sufficiently ajustment.
least one time soldering with switch up, but the drop of switch from the PCB and/or flux
ingress might happen depend on your manufacturing/soldering condition.
So please check if these phenomena do not happen with your manufacturing/soldering process.
capability. Therefore, be sure to perform soldering by reflow method.
LIGHT TOUCH SWITCH
REFERENCE SPECIFICATION
Panasonic Electronic Devices Co., Ltd.
Part No.
EVQP6YB55
Issue No.
20090918
6/10