kac-9630 ETC-unknow, kac-9630 Datasheet - Page 5

• Manufacturer Part Number: kac-9630
• Description: Cmos Image Sensor 126 H X 98 V Ultra Sensitive Global Shutter 580 Fps Monochrome Cis
• Manufacturer: ETC-unknow

IMAGE SENSOR SOLUTIONS
Pin Descriptions
Legend: (I=Input), (O=Output), (IO=Bi-directional), (P=Power), (D=Digital), (A=Analog).
www.kodak.com/go/imagers 585-722-4385
LCC
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
Name
d3
d2
d1
d0
hsync
vdd_od2
vss_od2
vdd_ana1
vss_ana1
vref_adc+
vref_adc-
vdd_ana2
vss_ana2
RSVD
RSVD
RSVD
dtest
reset
sda
sclk
vdd_pix
mclk
RSVD
vdd_od1
vss_od1
vsync
RSVD
RSVD
d7
d6
d5
d4
I/O
O
O
O
O
O
I
I
I
I
I
I
I
I
I
I
IO
I
I
I
I
I
IO
O
O
O
O
Typ
D
D
D
D
D
P
P
P
P
A
A
P
P
D
D
D
D
P
D
P
P
D
D
D
D
D
Description
Digital output. Bit 3 of the digital video output bus.
Digital output. Bit 2 of the digital video output bus.
Digital output. Bit 1 of the digital video output bus.
Digital output. Bit 0 of the digital video output bus. This pin is also the serial
pixel out pin.
Digital output. This pin is the horizontal synchronization signal.
3.3 volt supply for the digital IO buffers.
0 volt supply for the digital IO buffers
3.3 volt supply for analog circuits.
0 volt supply for analog circuits.
Reference ladder input for ADC. Note this pin should always be tied to
vdd_pix+ pin and bypassed with a 0.1µf capacitor.
Reference ladder input for ADC. Bypass with 0.1uF capacitor to ground.
3.3 volt supply for analog circuits.
0 volt supply for analog circuits.
Reserved, do not connected.
Reserved, do not connected.
Reserved, do not connected.
Factory test pin, do not connect.
Digital input with pull up resistor. Active low system reset pin.
I
open drain driver.
I
3.0 Volt supply for the pixel array. Note this pin should always be tied to
vref_adc+ pin and bypassed with a 0.1µf capacitor.
Digital input. This pin is the 10 MHz master clock.
Reserved, do not connect.
3.3 volt supply for the digital IO buffers.
0 volt supply for the digital IO buffers
Digital Bidirectional with pull down resistor. This pin is an output in video mode
and is the vertical synchronization signal. In snapshot mode the pin is an input
and is the external frame trigger.
Reserved, do not connect.
Reserved, do not connect.
Digital output. Bit 7 of the digital video output bus.
Digital output. Bit 6 of the digital video output bus.
Digital output. Bit 5 of the digital video output bus.
Digital output. Bit 4 of the digital video output bus.
2
2
C compatible serial interface data bus. The output stage of this pin has an
C compatible serial interface clock.
5
Email:[e-mail]