UPD3753CY-A NEC [NEC], UPD3753CY-A Datasheet
UPD3753CY-A
Available stocks
Related parts for UPD3753CY-A
UPD3753CY-A Summary of contents
Page 1
PIXELS CCD LINEAR IMAGE SENSOR WITH PERIPHERAL CIRCUIT DESCRIPTION µ The PD3753 is a 2088-pixel high sensitivity CCD (Charge Coupled Device) linear image sensor which changes optical images to electrical signal. µ The PD3753 consists of 2088-pixels photocell array ...
Page 2
BLOCK DIAGRAM Voltage amplifier V 19 OUT Reset feed-through level clamp circuit 20 AGND 2 Reset pulse/ clamp pulse generator Optical black 18 pixels, invalid photocell 2 pixels, valid photocell 2088 pixels, invalid photocell 2 pixels CCD ...
Page 3
PIN CONFIGURATION (Top View) CCD linear image sensor 22-pin plastic DIP (10.16 mm (400)) • µ PD3753CY-A No connection 1 No connection 2 Output drain voltage 3 No connection 4 No connection 5 No connection 6 No connection 7 No ...
Page 4
ABSOLUTE MAXIMUM RATINGS (T Parameter Output drain voltage V OD Shift register clock voltage φ 1 Transfer gate clock voltage V φ TG Note Operating ambient temperature T A Storage temperature T stg Note Use at the ...
Page 5
ELECTRICAL CHARACTERISTICS = +25° MHz, data rate = 1 MHz, storage time = 10 ms, input signal clock = 5 V φ light source : 3200 K halogen lamp ...
Page 6
TIMING CHART 1 φ TG φ 1 φ OUT V unstable period * OUT (12 pixels) Caution Be sure not to use this period (indicated the black level, because this part is unstable. TIMING CHART ...
Page 7
TG TIMING CHART φ TG φ 1 φ 2 Symbol t3 t6, t7 Remark The MAX. in the table above shows the operation range in which the output characteristics are kept almost enough ...
Page 8
DEFINITIONS OF CHARACTERISTIC ITEMS 1. Saturation voltage : V sat Output signal voltage at which the response linearity is lost. 2. Saturation exposure : SE Product of intensity of illumination (lx) and storage time (s) when saturation of output voltage ...
Page 9
Output impedance : Z O Impedance of the output pins viewed from outside. 7. Response : R Output voltage divided by exposure (lx•s). Note that the response varies with a light source (spectral characteristic). 8. Image lag : IL ...
Page 10
STANDARD CHARACTERISTIC CURVES (Reference Value) DARK OUTPUT TEMPERATURE CHARACTERISTIC 0.5 0.25 0 Operating Ambient Temperature T TOTAL SPECTRAL RESPONSE CHARACTERISTICS (without infrared cut filter) (T 100 ...
Page 11
POWER SUPPLY VOLTAGE RESPONSE RATIO CHARACTERISTIC 110 100 90 0 4.5 4.7 5.0 Power Supply Voltage (V) Data Sheet S16546EJ2V0DS µ PD3753 5.3 5.5 11 ...
Page 12
APPLICATION CIRCUIT EXAMPLE +5 V µ µ µ 0.1 F 0.1 F 74HC04 φ 1 φ 2 φ TG Caution Connect the No connection pins (NC) to GND ...
Page 13
PACKAGE DRAWING µ PD3753CY CCD LINEAR IMAGE SENSOR 22-PIN PLASTIC DIP (10.16 mm (400) ) (Unit : mm) 44.0±0.3 1st valid pixel 1 1.7±0 37.5 1.02±0.15 0.46±0.1 2.54±0.25 9.25±0 2.0 (1.99) 4.39±0.4 2.35±0.2 (5.42) 4.21±0.5 Name ...
Page 14
RECOMMENDED SOLDERING CONDITIONS When soldering this product highly recommended to observe the conditions as shown below. If other soldering processes are used the soldering is performed under different conditions, please make sure to consult with our ...
Page 15
NOTES ON HANDLING THE PACKAGES 1 DUST AND DIRT PROTECTING The optical characteristics of the CCD will be degraded if the cap is scratched during cleaning. Don’t either touch plastic cap surface by hand or have any object come in ...
Page 16
Data Sheet S16546EJ2V0DS µ PD3753 ...
Page 17
Data Sheet S16546EJ2V0DS µ PD3753 17 ...
Page 18
Data Sheet S16546EJ2V0DS µ PD3753 ...
Page 19
NOTES FOR CMOS DEVICES 1 VOLTAGE APPLICATION WAVEFORM AT INPUT PIN Waveform distortion due to input noise or a reflected wave may cause malfunction. If the input of the CMOS device stays in the area between V malfunction. Take care ...
Page 20
The information in this document is current as of February, 2006. The information is subject to change without notice. For actual design-in, refer to the latest publications of NEC Electronics data sheets or data books, etc., for the most ...