FS6370-01 American Microsystems, Inc., FS6370-01 Datasheet - Page 23

• Manufacturer Part Number: FS6370-01
• Description: EePROM Programmable 3-pll Clock Generator ic
• Manufacturer: American Microsystems, Inc.

13.1 Demo Kit Contents
13.2 Requirements
13.3 Board Setup and Software
1. At the appropriate disk drive prompt (A:\) unzip the
Figure 15: Opening Screen
compressed demo files to a directory of your choice.
Run setup.exe to install the software.
Demonstration board
Interface cable (DB25 to 6-pin connector)
Data sheet
Demonstration software, totaling 24 compressed
files which will expand to 1.8MB, including
fs6370.exe after installation.
PC running MS Windows 3.1x or 95/98 with an ac-
cessible parallel (LPT1) port. Software also runs on
Windows NT in a calculation mode only.
1.8MB available space on hard drive C.
Installation Instructions
EEPROM Programmable 3-PLL Clock Generator IC
EEPROM Programmable 3-PLL Clock Generator IC
EEPROM Programmable 3-PLL Clock Generator IC
EEPROM Programmable 3-PLL Clock Generator IC
23
2. Connect a power supply to the board: RED = power,
3. Connect the supplied interface cable to the parallel
4. Connect the clock outputs to the target application
13.4 Demo Program Operation
appear stating: “This version of the demo program cannot
communicate with the FS6370 hardware when running
on a Windows NT operating system. Do you want to con-
tinue anyway, using just the calculation features of this
program?” Clicking OK starts the program for calculation
only.
The opening screen is shown in Figure 15.
BLACK = ground.
port (DB25 connector) and to the demo board (6-pin
connector). Make sure the cable is facing away from
the board. Pin 1 is the red wire per Table 20.
board with a twisted-pair cable.
Launch the fs6370.exe program. Note that the
parallel port can not be accessed if your machine
is running Windows NT. A warning message will
FS6370-01
FS6370-01
FS6370-01
FS6370-01