ICS1893 Integrated Circuit Systems, ICS1893 Datasheet - Page 77

• Manufacturer Part Number: ICS1893
• Description: 3.3-V 10Base-T/100Base-TX Integrated PHYceiver
• Manufacturer: Integrated Circuit Systems

8.6.2 IEEE Reserved Bit (bit 4.14)
8.6.3 Remote Fault (bit 4.13)
8.6.4
ICS1893 Rev C 6/6/00
IEEE Reserved Bits (bits 4.12:10)
The ISO/IEC specification reserves this bit for future use. However, the ISO/IEC Standard also defines bit
4.14 as the Acknowledge bit.
When this reserved bit is read by an STA, the ICS1893 returns a logic zero. However, whenever an STA
writes to this reserved bit, it must use the default value specified in this data sheet. ICS uses some
reserved bits to invoke auxiliary functions. To ensure proper operation of the ICS1893, an STA must
maintain the default value of these bits. Therefore, ICS recommends that an STA always write the default
value of any reserved bits during all management register write operations.
Reserved bit 4.14 is a Command Override Write (CW) bit. Whenever bit 16.15 (the Command Register
Override bit) is logic:
•
•
When the ICS1893 Auto-Negotiation sublayer is enabled, the ICS1893 transmits the Remote Fault bit 4.13
to its remote link partner during the auto-negotiation process. The Remote Fault bit is part of the Link Code
Word that the ICS1893 exchanges with its remote link partner. The ICS1893 sets this bit to logic one
whenever it detects a problem with the link, locally. The data in this register is sent to the remote link partner
to inform it of the potential problem. If the ICS1893 does not detect a link fault, it clears bit 4.13 to logic zero.
Whenever the ICS1893:
•
•
The IEEE reserves these bits for future use. When an STA:
•
•
The ICS1893 uses some reserved bits to invoke auxiliary functions. To ensure proper operation of the
ICS1893, an STA must maintain the default value of these bits. Therefore, ICS recommends that during
any STA write operation, an STA write the default value to all reserved bits, even those bits that are Read
Only.
Zero, the ICS1893 isolates all STA writes to bit 4.14.
One, an STA can modify the value of bit 4.14.
Does not detect a link fault, the ICS1893 clears bit 4.13 to logic zero.
Detects a problem with the link, during the auto-negotiation process, this bit is set. As a result, the data
on this bit is sent to the remote link partner to inform it of the potential problem.
Reads a reserved bit, the ICS1893 returns a logic zero.
Writes to a reserved bit, it must use the default value specified in this data sheet.
ICS1893 - Release
Copyright © 2000, Integrated Circuit Systems, Inc.
All rights reserved.
77
Chapter 8 Management Register Set
June, 2000