EPM3064xxx Altera, EPM3064xxx Datasheet - Page 23

• Manufacturer Part Number: EPM3064xxx
• Description: MAX 3000A Programmable Logic Device Family
• Manufacturer: Altera

Altera Corporation
Notes to tables:
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10) The POR time for all MAX 3000A devices does not exceed 100 s. The sufficient V
(11) These devices support in-system programming for
C
C
Symbol
Table 15. MAX 3000A Device Capacitance
IN
I/O
See the
Minimum DC input voltage is –0.5 V. During transitions, the inputs may undershoot to –2.0 V or overshoot to
5.75 V for input currents less than 100 mA and periods shorter than 20 ns.
All pins, including dedicated inputs, I/O pins, and JTAG pins, may be driven before V
powered.
These values are specified under the recommended operating conditions, as shown in
The parameter is measured with 50% of the outputs each sourcing the specified current. The I
to high–level TTL or CMOS output current.
The parameter is measured with 50% of the outputs each sinking the specified current. The I
low–level TTL, PCI, or CMOS output current.
This value is specified during normal device operation. During power-up, the maximum leakage current is
±300 A.
This pull–up exists while devices are programmed in–system and in unprogrammed devices during power–up.
Capacitance is measured at 25 C and is sample–tested only. The
has a maximum capacitance of 20 pF.
3.0 V. The device is fully initialized within the POR time after V
and 0° C, contact Altera Applications.
Input pin capacitance
I/O pin capacitance
Operating Requirements for Altera Devices Data
Parameter
Figure 9
devices.
shows the typical output drive characteristics of MAX 3000A
V
V
IN
OUT
= 0 V, f = 1.0 MHz
= 0 V, f = 1.0 MHz
MAX 3000A Programmable Logic Device Family Data Sheet
Note (9)
–40° to 100° C. For in-system programming support between –40°
Sheet.
Conditions
CCINT
OE1
pin (high–voltage pin during programming)
reaches the sufficient POR voltage level.
CCINT
Min
Table 13 on page
CCINT
voltage level for POR is
OL
and V
OH
parameter refers to
parameter refers
Max
CCIO
8
8
22.
are
Unit
pF
pF
23