M41T80_11 STMICROELECTRONICS [STMicroelectronics], M41T80_11 Datasheet - Page 17

• Manufacturer Part Number: M41T80_11
• Description: Serial access real-time clock with alarm
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

M41T80
3.5
Note:
3.6
Output driver pin
When the AFE bit and SQWE bit are not set, the IRQ/OUT/SQW pin becomes an output
driver that reflects the contents of D7 of the control register. In other words, when D7 (OUT
bit) of address location 08h is a '0,' then the IRQ/OUT/SQW pin will be driven low.
The IRQ/OUT/SQW pin is an open drain which requires an external pull-up resistor.
Preferred power-on default
When powering the device up from ground (0 V), the following register bits are set to a '0'
state: ST; AFE; and SQWE. The following bits are set to a '1' state: OUT and 32KE (see
Table 6: Preferred power-on default values on page
Table 6.
1. If V
Power-up
CC
falls to a voltage, 0 V < V
(1)
Condition
Preferred power-on default values
CC
Doc ID 9074 Rev 5
< 2.0 V, these bits should be rewritten by the user.
ST
0
OUT
1
17).
AFE
0
SQWE
0
Clock operation
32KE
1
17/27