LMH7322_0706 NSC [National Semiconductor], LMH7322_0706 Datasheet - Page 6
![no-image](/images/no-image-200.jpg)
LMH7322_0706
Manufacturer Part Number
LMH7322_0706
Description
Dual 700 ps High Speed Comparator with RSPECL Outputs
Manufacturer
NSC [National Semiconductor]
Datasheet
1.LMH7322_0706.pdf
(24 pages)
www.national.com
t
t
t
sLE
hLE
PD_LE
Symbol
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
intended to be functional, but specific performance is not guaranteed. For guaranteed specifications and the test conditions, see the Electrical Characteristics.
Note 2: Human Body Model, applicable std. MIL-STD-883, Method 3015.7. Machine Model, applicable std. JESD22-A115-A (ESD MM std. of JEDEC)
Field-Induced Charge-Device Model, applicable std. JESD22-C101-C (ESD FICDM std. of JEDEC).
Note 3: Applies to both single-supply and split-supply operation. Continuous short circuit operation at elevated ambient temperature can result in exceeding the
maximum allowed junction temperature of 150°C.
Note 4: Short circuit test is a momentary test. See next note.
Note 5: The maximum power dissipation is a function of T
P
Note 6: Electrical Table values apply only for factory testing conditions at the temperature indicated. Factory testing conditions result in very limited self-heating
of the device such that T
T
Note 7: Typical values represent the most likely parametric norm as determined at the time of characterization. Actual typical values may vary over time and will
also depend on the application and configuration. The typical values are not tested and are not guaranteed on shipped production material.
Note 8: All limits are guaranteed by testing or statistical analysis.
Note 9: Positive current corresponds to current flowing into the device.
Note 10: Slew rate is the average of the positive and negative slew rate.
Note 11: Average Temperature Coefficient is determined by dividing the change in a parameter at temperature extremes by the total temperature change.
Connection Diagrams
Ordering Information
24-Pin LLP
A
D
Package
. See Applications section for information on temperature de-rating of this device.
= (T
NOPB
J(MAX)
Latch Setup Time
Latch Hold Time
Latch to Output Delay Time
– T
A
)/ θ
JA
. All numbers apply for packages soldered directly onto a PC Board.
Parameter
J
LMH7322SQX
Part Number
= T
LMH7322SQ
A
. No guarantee of parametric performance is indicated in the electrical tables under conditions of internal self-heating where T
Schematic
20183202
Package Marking
J(MAX)
L7322SQ
, θ
JA
. The maximum allowable power dissipation at any ambient temperature is
Conditions
6
4.5 Units Tape and Reel
1k Units Tape and Reel
Transport Media
(Note 8)
Min
Footprint
(Note 7)
Typ
102
906
37
(Note 8)
Max
NSC Drawing
SQA24A
20183201
Units
ps
ps
ps
J
>