STLM75DS2E STMICROELECTRONICS [STMicroelectronics], STLM75DS2E Datasheet - Page 13

• Manufacturer Part Number: STLM75DS2E
• Description: Digital temperature sensor and thermal watchdog
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

2.4
Note:
Interrupt mode
In Interrupt mode, the OS output first becomes active when the measured temperature
exceeds the T
Configuration register. Once activated, the OS can only be cleared by either putting the
STLM75 into Shutdown mode or by reading from any register (temperature, configuration,
T
when the measured temperature falls below the T
equal to the FT value.
The OS can only be cleared by putting the device into Shutdown mode or reading any
register. Thus, this interrupt/clear process is cyclical between the T
T
the OS/INT pin occur only when the STLM75 is read or placed into Shutdown mode.
Otherwise, OS/INT would remain active independently for any event.
Figure 5.
1. These interrupt mode resets of O.S. occur only when STLM75 is read or placed in shutdown. Otherwise,
OS
OS
O.S. would remain active indefinitely for any event..
, or T
, clear, T
HYS
HYS
OS output temperature response diagram
) on the device. Once the OS has been deactivated, it will only be reactivated
OS
, clear, T
value a consecutive number of times as determined by the FT value in the
Figure 5
OS
, clear, T
illustrates typical OS output temperature response.
HYS
, clear, and so forth). These interrupt mode resets of
HYS
value a consecutive number of times
OS
and T
HYS
events (i.e.,
13/37