ATMEGA3290PV ATMEL [ATMEL Corporation], ATMEGA3290PV Datasheet - Page 5

• Manufacturer Part Number: ATMEGA3290PV
• Description: 8-bit Microcontroller with 32K Bytes In-System Programmable Flash
• Manufacturer: ATMEL [ATMEL Corporation]

2.2
8021AS–AVR–12/06
Comparison between ATmega329P and ATmega3290P
The ATmega329P/3290P provides the following features: 32K bytes of In-System Programma-
ble Flash with Read-While-Write capabilities, 1K bytes EEPROM, 2K byte SRAM, 54/69 general
purpose I/O lines, 32 general purpose working registers, a JTAG interface for Boundary-scan,
On-chip Debugging support and programming, a complete On-chip LCD controller with internal
contrast control, three flexible Timer/Counters with compare modes, internal and external inter-
rupts, a serial programmable USART, Universal Serial Interface with Start Condition Detector,
an 8-channel, 10-bit ADC, a programmable Watchdog Timer with internal Oscillator, an SPI
serial port, and five software selectable power saving modes. The Idle mode stops the CPU
while allowing the SRAM, Timer/Counters, SPI port, and interrupt system to continue function-
ing. The Power-down mode saves the register contents but freezes the Oscillator, disabling all
other chip functions until the next interrupt or hardware reset. In Power-save mode, the asyn-
chronous timer and the LCD controller continues to run, allowing the user to maintain a timer
base and operate the LCD display while the rest of the device is sleeping. The ADC Noise
Reduction mode stops the CPU and all I/O modules except asynchronous timer, LCD controller
and ADC, to minimize switching noise during ADC conversions. In Standby mode, the crys-
tal/resonator Oscillator is running while the rest of the device is sleeping. This allows very fast
start-up combined with low-power consumption.
The device is manufactured using Atmel’s high density non-volatile memory technology. The
On-chip In-System re-Programmable (ISP) Flash allows the program memory to be repro-
grammed In-System through an SPI serial interface, by a conventional non-volatile memory
programmer, or by an On-chip Boot program running on the AVR core. The Boot program can
use any interface to download the application program in the Application Flash memory. Soft-
ware in the Boot Flash section will continue to run while the Application Flash section is updated,
providing true Read-While-Write operation. By combining an 8-bit RISC CPU with In-System
Self-Programmable Flash on a monolithic chip, the Atmel ATmega329P/3290P is a powerful
microcontroller that provides a highly flexible and cost effective solution to many embedded con-
trol applications.
The ATmega329P/3290P AVR is supported with a full suite of program and system develop-
ment tools including: C Compilers, Macro Assemblers, Program Debugger/Simulators, In-Circuit
Emulators, and Evaluation kits.
The ATmega329P and ATmega3290P differs only in pin count and pinout.
summarizes the different configurations for the four devices.
Table 2-1.
Device
ATmega329P
ATmega3290P
Configuration Summary
Flash
32K bytes
32K bytes
EEPROM
1K bytes
1K bytes
RAM
2K bytes
2K bytes
ATmega329P/3290P
LCD
Segments
4 x 25
4 x 40
Table 2-1 on page 5
General Purpose
I/O Pins
54
69
5