TS8388BCF ATMEL [ATMEL Corporation], TS8388BCF Datasheet - Page 33
![no-image](/images/no-image-200.jpg)
TS8388BCF
Manufacturer Part Number
TS8388BCF
Description
ADC 8-bit 1 GSPS
Manufacturer
ATMEL [ATMEL Corporation]
Datasheet
1.TS8388BCF.pdf
(57 pages)
2144C–BDC–04/03
Three possible line driving and back-termination scenarios are proposed (assuming V
0V):
1. 75
2. 50
3. 75
Note: This is no longer true if a 50 transmission line is used, as the latter is not matching the
buffer 75
Each differential output termination length must be kept identical. It is recommended to decou-
ple the midpoint of the differential termination with a 10 nF capacitor to avoid common mode
perturbation in case of slight mismatch in the differential output line lengths.
Too large mismatches (keep < a few mm) in the differential line lengths will lead to switching
currents flowing into the decoupling capacitor leading to switching ground noise.
The differential output voltage levels (75
levels, however it is possible to drive standard logic ECL circuitry like the ECLinPS logic line
from
At sampling rates exceeding 1 GSPS, it may be difficult to trigger any Acquisition System with
digital outputs. It becomes necessary to regenerate digital data and Data Ready by means of
external amplifiers, in order to be able to test the TS8388B at its optimum performance
conditions.
Each output voltage varies between -1V and -1.42V (respectively +1.4V and +1V), leading
to
V
Each output voltage varies between -1.02V and -1.35V (respectively +1.38V and +1.05V),
leading to
mode for V
Each output voltage varies between -1.6V and -0.8V (respectively +0.8V and +1.6V),
which are true ECL levels, leading to
tively +1.2V) common mode for V
to drive directly high input impedance storing registers, without terminating the 75
mission lines. In time domain, that means that the incident wave will reflect at the 75
transmission line output and travel back to the generator (i.e.: the 75 data output buffer).
As the buffer output impedance is 75 , no back reflection will occur.
Motorola
PLUSD
±
0.41V = 0.825V in differential, around -1.21V (respectively +1.21V) common mode for
impedance transmission lines, 75
impedance transmission lines, 50
impedance open transmission lines (Figure 36):
output impedance.
= 0V (respectively 2.4V).
®
.
±
PLUSD
0.33V = 660 mV in differential, around -1.18V (respectively +1.21V) common
= 0V (respectively 2.4V).
PLUSD
±
or 50
0.8V = 1.6V in differential, around -1.2V (respec-
= 0V (respectively 2.4V). Therefore, it is possible
differentially terminated (Figure 34):
differentially termination (Figure 35):
termination) are not ECL standard voltage
TS8388B
PLUSD
trans-
33
=