X4323 INTERSIL [Intersil Corporation], X4323 Datasheet - Page 8
![no-image](/images/no-image-200.jpg)
X4323
Manufacturer Part Number
X4323
Description
CPU Supervisor with 32K EEPROM
Manufacturer
INTERSIL [Intersil Corporation]
Datasheet
1.X4323.pdf
(21 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
X4323S8-2.7
Manufacturer:
Intersil
Quantity:
850
Company:
Part Number:
X4323S8I
Manufacturer:
Intersil
Quantity:
1 550
Company:
Part Number:
X4323S8I-2.7
Manufacturer:
Intersil
Quantity:
284
Serial Start Condition
All commands are preceded by the start condition,
which is a HIGH to LOW transition of SDA when SCL
is HIGH. The device continuously monitors the SDA
and SCL lines for the start condition and will not
respond to any command until this condition has been
met. See Figure 6.
Figure 6. Valid Start and Stop Conditions
Serial Acknowledge
Acknowledge is a software convention used to indi-
cate successful data transfer. The transmitting device,
either master or slave, will release the bus after trans-
mitting eight bits. During the ninth clock cycle, the
receiver will pull the SDA line LOW to acknowledge
that it received the eight bits of data. Refer to Figure 7.
The device will respond with an acknowledge after
recognition of a start condition and if the correct
Device Identifier and Select bits are contained in the
Slave Address Byte. If a write operation is selected,
the device will respond with an acknowledge after the
receipt of each subsequent eight bit word. The device
Figure 7. Acknowledge Response From Receiver
from Receiver
Data Output
Data Output
SCL from
SCL
SDA
Master
from
8
Start
Start
1
X4323, X4325
Serial Stop Condition
All communications must be terminated by a stop con-
dition, which is a LOW to HIGH transition of SDA when
SCL is HIGH. The stop condition is also used to place
the device into the Standby power mode after a read
sequence. A stop condition can only be issued after the
transmitting device has released the bus. See Figure 6.
will acknowledge all incoming data and address bytes,
except for the Slave Address Byte when the Device
Identifier and/or Select bits are incorrect.
In the read mode, the device will transmit eight bits of
data, release the SDA line, then monitor the line for an
acknowledge. If an acknowledge is detected and no
stop condition is generated by the master, the device
will continue to transmit data. The device will terminate
further data transmissions if an acknowledge is not
detected. The master must then issue a stop condition
to return the device to Standby mode and place the
device into a known state.
8
Stop
Acknowledge
9
March 29, 2005
FN8122.0