FT232HL FTDI [Future Technology Devices International Ltd.], FT232HL Datasheet - Page 36

• Manufacturer Part Number: FT232HL
• Description: FT232H Single Channel Hi-Speed USB to Multipurpose UART/FIFO IC
• Manufacturer: FTDI [Future Technology Devices International Ltd.]

MPSSE mode is enabled using the FT_SetBitMode D2xx driver command with a hex value of 0x02. A hex
value of 0x00 will reset the device. See application note
examples.
The MPSSE command set is fully described in application note
MPSSE and MCU Host Bus Emulation Modes
The Adaptive Clock mode correlates the CLK signal with a return clock RTCK. This is a technique used by
ARM
The FT232H will assert the TCK line and wait for the RTCK to be returned from the target device to
GPIOL3 line before changing the TDO (data out line).
Figure 4.15 Adaptive Clocking Interconnect
Figure 4.16: Adaptive Clocking waveform.
Adaptive clocking is not enabled by default.
For further details on MPSSE adaptive clocking please refer to AN_108
MPSSE and MCU Host Bus Emulation Modes
RTCK
TDO
TCK
4.8.1
®
processors.
FT2232H
GPIOL3
MPSSE Adaptive Clocking
TDO
TCK
Copyright © 2011 Future Technology Devices International Limited
FT232H SINGLE CHANNEL HI-SPEED USB TO MULTIPURPOSE UART/FIFO IC
RTCK
ARM CPU
AN135 – MPSSE Basics
TDO changes on falling
AN108 - Command Processor For
edge of TCK
Command Processor For
Document No.: FT_000288
Clearance No.: FTDI #199
for more details and
Datasheet Version 1.3
36