A29L800 AMIC Technology, A29L800 Datasheet - Page 17

• Manufacturer Part Number: A29L800
• Description: 1M X 8 Bit / 512K X 16 Bit CMOS 3.0 Volt-only/ Boot Sector Flash Memory
• Manufacturer: AMIC Technology

Note:
1. See Table 1 for description of bus operations.
2. All values are in hexadecimal.
3. Except when reading array or autoselect data, all bus cycles are write operation.
4. Data bits I/O
5. Address bits A18 - A11 are don't cares for unlock and command cycles, unless SA or PA required.
6. No unlock or command cycles required when reading array data.
7. The Reset command is required to return to reading array data when device is in the autoselect mode, or if I/O
8. The fourth cycle of the autoselect command sequence is a read cycle.
9. The data is 00h for an unprotected sector and 01h for a protected sector. See “Autoselect Command Sequence” for more
10. The Unlock Bypass command is required prior to the Unlock Bypass Program command.
11. The Unlock Bypass Reset command is required to return to reading array data when the device is in the unlock bypass
12. The system may read and program in non-erasing sectors, or enter the autoselect mode, when in the Erase Suspend mode.
13. The Erase Resume command is valid only during the Erase Suspend mode.
PRELIMINARY
(while the device is providing status data).
information.
mode.
15
~I/O
(September, 2002, Version 0.2)
8
are don’t care for unlock and command cycles.
17
AMIC Technology, Inc.
A29L800 Series
5
goes high