D38999/49 Defense Supply Center, D38999/49 Datasheet - Page 26

• Manufacturer Part Number: D38999/49
• Description: D38999K / D38999J 500 Cycle Contact
• Manufacturer: Defense Supply Center

D38999/20
Specification
Sheet Number
(see supplement)
b. Identification (series III and IV).
applicable military standard. All positions shall be identified on the front and rear faces of the insert except
where space limitations make this impracticable. Location of contact identifying characters shall be in close
proximity to the holes but need not be placed exactly where indicated on the standard. The preferred color
of the contact identifying character is white. When the background is a color against which white is difficult
to distinguish, a color will be chosen for which the identifying character can be easily distinguished.
over the certification marks "JAN" and "J", respectively, to indicate that items so marked or identified are
manufactured to, and meet all the requirements of military specification. Accordingly, items acquired to,
and meeting all of the criteria specified herein and in applicable specifications shall bear the certification
mark "JAN" except that items too small to bear the certification mark "JAN" shall bear the letter "J". The
"JAN" or "J" shall be placed immediately before the PIN except that if such location would place a hardship
on the manufacturer in connection with such marking, the "JAN" or "J" may be located on the first line
above or below the PIN. Items furnished under contracts or orders which either permit or require deviation
from the conditions or requirements specified herein or in applicable specifications shall not bear "JAN" or
"J". In the event an item fails to meet the requirements of this specification and the applicable specification
sheets or associated detail specifications, the manufacturer shall remove the "JAN" or the "J" from the
sample tested and also from all items represented by the sample. The "JAN" or "J" certification mark shall
not be used on products acquired to contractor drawings or specification. The United States Government
has obtained Certificate of Registration No. 504,860 for the certification mark "JAN".
3.43.1 Contact location identification. Contact locations shall be identified as indicated on the
3.43.2 JAN brand. The United States Government has adopted, and is exercising legitimate control
c. Lot number - (000010).
d. JAN prefix - (see 3.43.2)
Note: The “JAN” or “J” is not part of the PIN but indicates a certification.
(see 1.3.1c & 3.4.8.2)
Class
W
Shell size letter
(see table XI)
J
MIL-DTL-38999K
(see MIL-STD-1560)
26
arrangement
Insert
30
Contact Style
(see 1.3.1e)
P
(see figure 6,
Polarization
series III, figure 7
series IV)
(a letter is required
for all positions)
N