LC104S1 ETC1 [List of Unclassifed Manufacturers], LC104S1 Datasheet - Page 25

• Manufacturer Part Number: LC104S1
• Description: PRELIMINARY SPECIFICATION
• Manufacturer: ETC1 [List of Unclassifed Manufacturers]

9. PRECAUTIONS
9-1. MOUNTING PRECAUTIONS
9-2. OPERATING PRECAUTIONS
Please pay attention to the following when you use this TFT LCD module.
(1) You must mount a module using holes arranged in four corners or four sides.
(2) You should consider the mounting structure so that uneven force(ex. Twisted stress) is not applied
(3) Please attach a transparent protective plate to the surface in order to protect the polarizer.
(4) You should adopt radiation structure to satisfy the temperature specification.
(5) Acetic acid type and chlorine type materials for the cover case are not describe because the former
(6) Do not touch, push or rub the exposed polarizers with glass, tweezers or anything harder than HB
(7) When the surface becomes dusty, please wipe gently with absorbent cotton or other soft materials
(8) Wipe off saliva or water drops as soon as possible. Their long time contact with polarizer causes
(9) Do not open the case because inside circuits do not have sufficient strength.
(1) The spike noise causes the mis-operation of circuits. It should be lower than following voltage :
(2) Response time depends on the temperature. (In lower temperature, it becomes longer.)
(3) Brightness depends on the temperature. (In lower temperature, it becomes lower.)
(4) Be careful for condensation at sudden temperature change. Condensation makes damage to
(5) When fixed patterns are displayed for a long time, remnant image is likely to occur.
(6) Module has high frequency circuits. Sufficient suppression to the electromagnetic interference
to the module.
And the case on which a module is mounted should have sufficient strength so that external force
is not transmitted directly to the module.
Transparent protective plate should have sufficient strength in order to the resist external force.
generates corrosive gas of attacking the polarizer at high temperature and the latter causes circuit
break by electro-chemical reaction.
pencil lead. And please do not rub with dust clothes with chemical treatment.
Do not touch the surface of polarizer for bare hand or greasy cloth. (Some cosmetics are determined
to the polarizer.)
like chamois soaks with petroleum benzene. Normal-hexane is recommended for cleaning the
adhesives used to attach front / rear polarizers. Do not use acetone, toluene and alcohol because
they cause chemical damage to the polarizer.
deformations and color fading.
V = ± 200 mV (Over and under shoot voltage)
And in lower temperature, response time (required time that brightness is stable after turned on)
becomes longer.
polarizer or electrical contacted parts. And after fading condensation, smear or spot will occur.
shall be done by system manufacturers. Grounding and shielding methods may be important to
minimized the interference.
Vernissakatu 8A
01300 Vantaa, Finland
http://www.alpha.fi
Alpha Point Ltd.
Liquid Crystal Display LC104S1-A1
Tel.: [phone]
Fax: [phone]
SPECIFICATION
Page 25 / 28