LC104S1 ETC1 [List of Unclassifed Manufacturers], LC104S1 Datasheet - Page 7

• Manufacturer Part Number: LC104S1
• Description: PRELIMINARY SPECIFICATION
• Manufacturer: ETC1 [List of Unclassifed Manufacturers]

5. The output of the inverter must have symmetrical (negative and positive) voltage waveform and
6. Let’s define the brightness of the lamp after being lighted for 5 minutes as 100%.
7. The lamp power consumption shown above does not include loss of external inverter.
8. The life is determined as the time at which brightness of the lamp is 50% compared to that of initial
9. Do not attach a conducting tape to lamp connecting wire.
T
The used lamp current is the lamp typical current.
symmetrical current waveform.(Unsymmetrical ratio is less than 10%) Please do not use the inverter
which has unsymmetrical voltage and unsymmetrical current and spike wave.
Lamp frequency may produce interface with horizontal synchronous frequency and as a result this may
cause beat on the display. Therefore lamp frequency shall be as away possible from the
horizontal synchronous frequency and from its harmonics in order to prevent interference.
value at the typical lamp current on condition of continuous operating at 25 ± 2°C.
If the lamp wire attach to a conducting tape, TFT-LCD Module has a low luminance and the inverter
has abnormal action. Because leakage current is occurred between lamp wire and conducting tape.
S
is the time required for the brightness of the center of the lamp to be not less than 95%.
Vernissakatu 8A
01300 Vantaa, Finland
http://www.alpha.fi
Alpha Point Ltd.
Liquid Crystal Display LC104S1-A1
Tel.: [phone]
Fax: [phone]
SPECIFICATION
Page 7 / 28