LUCL8574DP-D AGERE [Agere Systems], LUCL8574DP-D Datasheet

no-image

LUCL8574DP-D

Manufacturer Part Number
LUCL8574DP-D
Description
L8574D Resistive Subscriber Line Interface Circuit(SLIC), Ring Relay,and Protector(SRP)for Long Loop and TR-57 Applications
Manufacturer
AGERE [Agere Systems]
Datasheet
October 1998
Features
Description
The L8574 is a resistive subscriber line interface cir-
cuit (SLIC) that is optimized for long loop applica-
tions, such as Bellcore TR-NWT-000057
requirements for digital loop carrier (DLC) applica-
tions. It interfaces the low-voltage circuits on an ana-
log line card to the Tip/Ring subscriber loop. The
L8574 does not supply dc current to the subscriber
loop; external resistors are used for this purpose.
Relay, and Protector (SRP) for Long Loop and TR-57 Applications
Low-power scan mode for low on-hook power dis-
sipation (55 mW max)
Low active power dissipation; talk or on-hook
transmission (240 mW max)
Distortion-free on-hook transmission
Eight operating states via latched paralleled data
inputs with channel select feature
Precision fixed 28 mA current limiter
Integrated protection
No external protection device required
Integrated ringing access relay
Ring trip detector
Loop closure detector with hysteresis
Relay driver
Battery noise cancellation
Thermal protection
44-pin, surface-mount, plastic package (PLCC)
L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring
Included in the L8574 are a solid-state ringing
access switch and a line break switch. Also included
is a relay driver for an external (test) access mechan-
ical relay.
State control is via four latched parallel data inputs. A
chip select feature allows the user to enable, disable,
or reset the data latches to a known logic state.
The L8574 offers a low-power scan state to minimize
power to less than 55 mW in the on-hook state. The
L8574 also supports on-hook transmission. The
active power in both the talk or on-hook transmission
mode is also very low (<240 mW). Current is limited
to a fixed value of 25 mA by an internal precision
current-limit circuit.
Because of the internal architecture of the L8574
SLIC and because of the power rating of the associ-
ated external feed resistors, the L8574 will meet most
surge requirements without use of an external sec-
ondary protection device. Internal circuitry steers
both positive and negative faults to fault ground. Neg-
ative faults are not dumped into battery.
The L8574 is a two-chip line interface solution pack-
aged in a single, 44-pin PLCC package. The Tip and
Ring drive amplifiers, the XMT amplifier, the receive
interface, and battery noise cancellation circuits are
fabricated in a 90 V complementary bipolar (CBIC)
process. The ring access switch, line break switch,
battery switch, current-limit, protection functions,
supervision, and control functions are fabricated in a
320 V dielectrically isolated bipolar-CMOS-DMOS
(BCDMOS) process. The device is available in a
44-pin PLCC package.

Related parts for LUCL8574DP-D

LUCL8574DP-D Summary of contents

Page 1

October 1998 L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Features Low-power scan mode for low on-hook power dis- sipation (55 mW max) Low active power dissipation; talk or on-hook ...

Page 2

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Contents Features ....................................................................................................................................................................1 Description ................................................................................................................................................................1 Architectural Diagram ................................................................................................................................................4 Pin Information ..........................................................................................................................................................4 Absolute Maximum Ratings.......................................................................................................................................6 Electrical Characteristics ...........................................................................................................................................7 Ring Trip Detector ...................................................................................................................................................8 Battery ...

Page 3

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Tables Table 1. Pin Descriptions ........................................................................................................................................... 5 Table 2. Operating Conditions and Powering ............................................................................................................ 7 Table 3. Ring ...

Page 4

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Architectural Diagram AGND + AX – PROTECT V BF PROTECT FGND Pin Information PRA PRB NSTAT ...

Page 5

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Pin Information (continued) Table 1. Pin Descriptions Pin Symbol Type 1 IRCV I Receive Signal Input (+). The ...

Page 6

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Pin Information (continued) Table 1. Pin Descriptions (continued) Pin Symbol Type 33 CLIM — BAT2 35 AGND — 36 ...

Page 7

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Electrical Characteristics In general, minimum and maximum values are testing requirements. However, some parameters may not be tested ...

Page 8

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Electrical Characteristics Ring Trip Detector Table 3. Ring Trip Detector Parameter 1 Ringing Source : Frequency (f) dc Voltage ac Voltage 2 ...

Page 9

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Electrical Characteristics Fault Protection Pins PT, PR, and V BF Pins PT, PR, and V are protected by ...

Page 10

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Electrical Characteristics Fault Protection (continued) Loss of Power Supplies The L8574 must protect itself from lightning and power cross voltages on Tip ...

Page 11

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Electrical Characteristics Fault Protection (continued) Loss of Power Supplies (continued) Table 7. Analog Signal Pins Parameter PT and ...

Page 12

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Electrical Characteristics Fault Protection (continued) Loss of Power Supplies (continued) Table 7. Analog Signal Pins (continued) Parameter RCVN: Input Voltage Range Input ...

Page 13

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Electrical Characteristics Transmission Characteristics Transmit direction is Tip/Ring to XMT. Receive direction is IRCV/RCVN to Tip/Ring. Table 8. ...

Page 14

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Electrical Characteristics Data Interface and Logic Table 9. Logic Inputs (CE, CS, and B0—B3) and Output NSTAT 1 Parameter High-level Input Voltage ...

Page 15

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Electrical Characteristics Switch Characteristics Table 12. Battery Switch (SW1) and Ring Break Switch (SW2) Parameter 1 Off-state : ...

Page 16

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Electrical Characteristics Switch Characteristics (continued LIMIT R ON –V max –1.5 V +1 –I LIMIT ...

Page 17

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Operating States (continued) Disconnect State Forward disconnect state. The receive transmission path is powered down; the transmit path ...

Page 18

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Operating States (continued) Intermediate Talk State Talk state with an increased and current-limited out- put impedance. Same as talk state. The current ...

Page 19

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Applications (continued) General (continued) RESISTOR MODULE R2 200 F1 TIP F2 RING R1 200 R10 600 k C ...

Page 20

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Applications (continued) General (continued) Table 15. External Components Required Comp. Function F1 Fuse Protector F2 Fuse Protector R dc Feed Protection 1 ...

Page 21

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Applications (continued) General (continued) Table 15. External Components Required (continued) Comp. Function C Battery Noise Cancellation CBN2 5 ...

Page 22

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Applications (continued) Resistor Module The L8574 requires certain external resistors at the Tip and Ring interface. Because of matching and protection requirements, ...

Page 23

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Applications (continued) Resistor Module (continued RING PR RGBN R 1 ...

Page 24

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Applications (continued) Resistor Module (continued) Resistors R —R set the gain of the SLIC in the 3 6 transmit (2-wire to 4-wire) ...

Page 25

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Applications (continued) Protection (continued) sense inputs, TS and RS, are protected with diodes to battery (V ) and ...

Page 26

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Applications (continued) On-Hook Transmission During the on-hook transmission and talk/on-hook transmission states, the L8574 provides 750 A dc bias current out of ...

Page 27

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Applications (continued) Thermal Shutdown If the silicon temperature rises above a nominal 145 C, the L8574 will enter ...

Page 28

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications dc Characteristics (continued) V-I Characteristics (continued) In longer loops, the L8574 will operate in the linear region of operation, and in short ...

Page 29

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 ac Design (continued) Codec Features and Selection Summary (continued) Third-Generation Codecs This class of devices includes the gains, ...

Page 30

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications ac Design (continued) Design Equations (continued) RESISTOR MODULE 100 k 200 k 200 ...

Page 31

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 ac Design (continued) Design Equations (continued) Using the circuit of Figure 12, the ratio of capacitors C and ...

Page 32

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications ac Design (continued) Design Equations (continued practical design example, design the interface for the following set of requirements ...

Page 33

Data Sheet L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Application Diagram RESISTOR NETWORK 200 F1 TIP F2 RING 200 0. 0.01 F 19.6 k ...

Page 34

L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring Relay, and Protector (SRP) for Long Loop and TR-57 Applications Outline Diagram 44-Pin PLCC Dimensions are in millimeters. PIN #1 IDENTIFIER 17.65 MAX 16.66 MAX ZONE 1 ...

Page 35

... Relay, and Protector (SRP) for Long Loop and TR-57 Applications October 1998 Ordering Information Device Part No. LUCL8574DP-D Resistive SLIC, Ring Relay, and Protector for Long Loop and TR-57 Applications LUCL8574DP-DT Resistive SLIC, Ring Relay, and Protector for Long Loop and TR-57 Applications Lucent Technologies Inc. Description (Tape and Reel, Dry-bagged) Package Comcode ...

Page 36

For additional information, contact your Microelectronics Group Account Manager or the following: INTERNET: http://www.lucent.com/micro E-MAIL: docmaster@micro.lucent.com N. AMERICA: Microelectronics Group, Lucent Technologies Inc., 555 Union Boulevard, Room 30L-15P-BA, Allentown, PA 18103 1-800-372-2447, FAX 610-712-4106 (In CANADA: 1-800-553-2448, FAX 610-712-4106) ASIA ...

Related keywords