GR2316 GENNUM [Gennum Corporation], GR2316 Datasheet - Page 13

• Manufacturer Part Number: GR2316
• Description: Genblue Module
• Manufacturer: GENNUM [Gennum Corporation]

7. FCC, Industry Canada (IC) and EU Regulatory
7.1 FCC Notice
7.2 Industry Canada (IC) Notice
Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
•
•
This device complies with RSS-210 requirements of Industry Canada. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
The GR2316 module has been designed to operate with antennas selectable by
the user. To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropic radiated power
(EIRP) is not more than that required for successful communication. The GR2316
module has been designed to operate with an antenna having a maximum gain of
+4.4 dBi. Antennas having a higher gain are strictly prohibited per regulations of
Industry Canada. The required antenna impedance is 50 ohms.
32197 - F
may cause undesired operation.
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Consult the dealer or an experienced radio/TV technician for help
: This equipment has been tested and found to comply with the limits for a
May 2006
GR2316 / GR2320 Data Sheet
13 of 17