MAX11132ATI+ Maxim Integrated, MAX11132ATI+ Datasheet - Page 25

• Manufacturer Part Number: MAX11132ATI+
• Description: Analog to Digital Converters - ADC 12Bit 8Ch 3Msps Precision ADC
• Manufacturer: Maxim Integrated

Specifications of MAX11132ATI+

• Rohs: yes
• Number Of Channels: 8/4
• Architecture: SAR
• Conversion Rate: 3 MSPs
• Resolution: 12 bit
• Input Type: Single-Ended/Pseudo-Differential
• Snr: 72.3 dB
• Interface Type: 3-Wire, QSPI, SPI
• Operating Supply Voltage: 2.35 V to 3.6 V
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Package / Case: TQFN-28
• Maximum Power Dissipation: 2758 mW
• Minimum Operating Temperature: - 40 C
• Number Of Converters: 1
• Voltage Reference: 1 V

The MAX11129–MAX11132 feature three power-down
modes.
The devices shut down when the SPM bits in the ADC
Configuration register are asserted
two shutdown options:
U Full shutdown where all circuitry is shutdown.
U Partial shutdown where all circuitry is powered down
Table 5. Power Management Modes
Table 6. ADC Configuration Register
Maxim Integrated
except for the internal bias generator.
PM1
CONFIG_SETUP
0
0
1
1
BIT NAME
REFSEL
AVGON
PM0
0
1
0
1
AutoShutdown
AutoStandby
15:11
BIT
10
9
Normal
MODE
—
DEFAULT
Power-Down Mode
STATE
3Msps, Low-Power, Serial 12-/10-Bit,
N/A
(Table
0
0
Static Shutdown
All circuitry is fully powered up at all times.
The device enters full shutdown mode at the end of each conversion. All circuitry
is powered down. The device powers up following the falling edge of CS. It takes 2
cycles before valid conversions take place. The information in the registers is retained.
The device powers down all circuitry except for the internal bias generator. The part
powers up following the falling edge of CS. It takes 2 cycles before valid conversions
take place. The information in the registers is retained.
Unused.
6). There are
Set to 10000 to select the ADC Configuration register.
Set to 1 to turn averaging on. Valid for internal clock mode only.
Set to 0 to turn averaging off.
REFSEL
0
1
VOLTAGE REFERENCE
External single-ended
External differential
When the PM_ bits in the ADC Mode Control register are
asserted
edge of CS in the next frame. The device powers up
again at the following falling edge of CS. There are two
available options:
U AutoShutdown where all circuitry is shutdown.
U AutoStandby where all circuitry are powered down
The device shuts down after all conversions are complet-
ed. The device powers up again at the next falling edge
of CNVST or at the rising edge of CS after the SWCNV
bit is asserted.
except for the internal bias generator.
MAX11129–MAX11132
(Table
FUNCTION
8-/16-Channel ADCs
AutoShutdown with External Clock Mode
AutoShutdown with Internal Clock Mode
FUNCTION
5), the device shuts down at the rising
AIN15 ( for the 16-channel devices)
REF- CONFIGURATION
REF-
25