88-00151-00 Murata Wireless Solutions, 88-00151-00 Datasheet - Page 28
![no-image](/images/no-image-200.jpg)
88-00151-00
Manufacturer Part Number
88-00151-00
Description
WiFi / 802.11 Modules SN8200 Wifi Network Controller Module
Manufacturer
Murata Wireless Solutions
Datasheet
1.88-00151-00.pdf
(29 pages)
Specifications of 88-00151-00
Rohs
yes
Protocol Supported
802.11 b/g/n
Frequency Band
2.4 GHz
Data Rate
11 Mbps, 54 Mbps
Interface Type
I2C, SPI, UART
Transmit Power (max)
18 dBm
Antenna Connector Type
On-board
Operating Supply Voltage
3.3 V
Supply Current Transmitting
370 mA
Supply Current Receiving
110 mA
Maximum Operating Temperature
+ 85 C
Dimensions
30.5 mm x 19.4 mm x 2.8 mm
Minimum Operating Temperature
- 30 C
Modulation Technique
CCK, DSSS
Tradename
SyNode
Notwithstanding the foregoing, the product shall not be used in any application listed below which
requires especially high reliability for the prevention of such defect as may directly cause damage to
the third party's life, body or property.
- Aircraft equipment
- Aerospace equipment
- Undersea equipment
- Power plant control equipment
- Medical equipment
- Transportation equipment (vehicles, trains, ships, etc.)
- Traffic signal equipment
- Disaster prevention / crime prevention equipment
- Application of similar complexity and/or reliability requirements to the applications listed in the
above.
3.
expressly specified in the specifications shall be effective for a period of six (6) months from the
date of delivery. SyChip shall not be liable for any defects that occur in dry packed products that are
installed more than six (6) months after shipment.
SyChip’s liability under this warranty shall be limited to products that are returned during the
warranty period to the address designated by SyChip and that are determined by SyChip not to
conform to such warranty. If SyChip elects to repair or replace such products, SyChip shall have
reasonable time to repair such products or provide replacements. Repaired products shall be
warranted for the remainder of the original warranty period. Replaced products shall be warranted
for a new full warranty period.
For avoidance of doubt, SyChip shall not be liable for any defects that are caused by neglect, misuse
or mistreatment by an entity other than SyChip including improper installation or testing, or for any
products that have been altered or modified in any way by an entity other than SyChip. Moreover,
SyChip shall not be liable for any defects that result from your or third party’s design, specifications
or instructions for such products.
SyChip’s warranty as provided in Clause 1 above that the products comply with descriptions
v) Since the applied soldering method may deteriorate the reliability, thorough
vi) In case the product is to be used in equipment or electric circuit that requires high
evaluation is recommended.
safety or reliability function or performance, sufficient reliability evaluation
checks for safety shall be performed before commercial shipment and moreover,
due consideration to install a protective circuit is strongly recommended at
customer's design stage. Please provide an appropriate fail-safe function on your
product to prevent any damages that may be caused by the abnormal function or
the failure of our product.
Page 28 of 29
SN8200 User Manual and Datasheet v1.1