AS1364-BTDT-33-1k ams, AS1364-BTDT-33-1k Datasheet - Page 10

• Manufacturer Part Number: AS1364-BTDT-33-1k
• Description: Low Dropout Controllers - LDO
• Manufacturer: ams

Specifications of AS1364-BTDT-33-1k

• Rohs: yes
• Input Voltage Max: 5.5 V
• Output Voltage: 3.3 V
• Output Current: 1 A
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: TDFN-8
• Input Voltage Min: 2 V
• Minimum Operating Temperature: - 40 C

AS1364
Datasheet - D e t a i l e d D e s c r i p t i o n
8.1 Output Voltage Selection
At the factory trimmed versions of the AS1364 offering the bypass pin
(see Ordering Information on page
For the adjustable AS1364-AD, an output voltage between +1.2V and +5V can be set by using two external resistors
mode, V
Where:
V
A simplification of R
Since the input bias current at SET is less than 100nA, large resistance values can be used for R1 and R2 to minimize power consumption and
therefore increasing efficiency.
Note: Up to 125k is acceptable for R2. If the SET pin is connected to GND without a resistor, 3.3V will be set as output voltage.
In preset voltage mode, the impedance from SET to GND should be less than 10k or spurious conditions may cause the voltage at SET to
exceed the 50mV threshold.
Figure 17. Adjustable Output Voltage Typical Application
8.2 Shutdown
If pin EN is connected to GND the AS1364 is disabled. In shutdown mode all internal circuits are turned off, reducing supply current to 10nA
(typ). For normal device operation pin EN must be connected to IN. During shutdown, POK goes low.
When in shutdown, a 5k (typ) discharge path is connected between the output pin and ground.
8.3 Power-OK
The AS1364 features a power-ok indicator that asserts when the output voltage falls out of regulation. The open-drain POK output goes low
when output voltage at OUT falls 6% below its nominal value. A 100k pull-up resistor from POK to a (typically OUT) provides a logic control
signal.
POK can be used as a power-on-reset (POR) signal to a microcontroller or can drive an external LED to indicate a power failure condition.
Note: POK is low during shutdown.
www.austriamicrosystems.com
SET/BYP
OUT
= 1.2V ±0.03V
V
is determined by:
IN
1
and R
C
4.7µF
2
IN
On
Off
selection is:
18).
GND
EN
IN
IN
4
3
2
8
V
OUT
R
1
=
=
AS1364
R
V
2
SETBYP



-------------------- - 1
V
Revision 1.8
(see Figure
V
SETBYP
OUT



1
+
–
R
----- -
R
), the output voltage is then set to an internally trimmed voltage


1
2
5
OUT
6
OUT
7
SET/BYP
1
POK


Reset Output
R
R
2
1
(see Figure
C
4.7µF
OUT
V
17). In this
OUT
10 - 19
(EQ 1)
(EQ 2)