GT28F320C3TA110 Intel, GT28F320C3TA110 Datasheet - Page 19

• Manufacturer Part Number: GT28F320C3TA110
• Description: IC FLASH 32MBIT 110NS 47MBGA
• Manufacturer: Intel

Specifications of GT28F320C3TA110

• Rohs Status: RoHS non-compliant
• Format - Memory: FLASH
• Memory Type: Advanced + Boot Block FLASH
• Memory Size: 32M (2M x 16)
• Speed: 110ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 47-MBGA
• Other names: 820978

4.0
4.1
4.1.1
4.1.2
Datasheet
Modes of Operation
Read Mode
The flash memory has four read modes (read array, read identifier, read status, and CFI query), and
two write modes (program and erase). Three additional modes (erase suspend to program, erase
suspend to read, and program suspend to read) are available only during suspended operations.
Table 7, “Command Bus Operations” on page 24
Descriptions” on page 25
“Write State Machine States” on page 50
Read Array
When RP# transitions from V
respond to the read-control inputs (CE#, address inputs, and OE#) without any additional CUI
commands.
When the device is in read array mode, four control signals control data output.
In addition, the address of the desired location must be applied to the address pins. If the device is
not in read-array mode, as would be the case after a Program or Erase operation, the Read Array
command (0xFF) must be issued to the CUI before array reads can occur.
Read Identifier
The read-identifier mode outputs three types of information: the manufacturer/device identifier, the
block locking status, and the protection register. The device is switched to this mode by issuing the
Read Identifier command (0x90). Once in this mode, read cycles from addresses shown in
retrieve the specified information. To return to read-array mode, issue the Read Array command
(0xFF).
•
•
•
•
WE# must be logic high (V
CE# must be logic low (V
OE# must be logic low (V
RP# must be logic high (V
summarize the commands used to reach these modes.
IL
IL
IL
IH
IH
(reset) to V
)
)
)
)
Intel
is a comprehensive chart showing the state transitions.
IH
, the device defaults to read-array mode and will
£
Advanced+ Boot Block Flash Memory (C3)
and
Table 8, “Command Codes and
Appendix A,
Table 6
19