WIZ1000-US WIZnet, WIZ1000-US Datasheet - Page 12

• Manufacturer Part Number: WIZ1000-US
• Description: Ethernet Modules 1 PORT SERIAL-ENET DEVICE SERVER 110V
• Manufacturer: WIZnet

Specifications of WIZ1000-US

• Rohs: yes
• Product: Serial to Ethernet Servers
• Interface Type: RS-232
• Operating Supply Voltage: 5 V
• Maximum Operating Temperature: + 70 C
• Dimensions: 75 mm x 45 mm
• Minimum Operating Temperature: 0 C

Copyright © WIZnet All Rights Reserved
ⓓ
PPPoE mode.
Static: “Static” is the option for setting WIZ1000 with static IP address. First select MAC
address that you want to set it as static IP in ‘board list’. Then, the “Local IP, Subnet,
Gateway boxes are enabled. Input Static IP address and click “setting” button. Then IP is set
as you want. (PPPoE ID, Password box will be disabled)
DHCP: Set this option to use DHCP mode. First, check ‘DHCP’ and click ‘Setting’ button. If IP
address is successfully acquired from DHCP server, the MAC address will be displayed on the
board list. (It takes some time to acquire IP address from DHCP server)
When a module on the board list is selected, IP address, Subnet mask and Gateway are
displayed. If module could not acquire network information from DHCP server, IP address,
Gateway Address and Subnet mask will be initialized to 0.0.0.0.
PPPoE : WIZ1000 supports PPPoE for ADSL user. When you select PPPoE in “IP Configuration
Method” PPPoE ID and Password box will be enabled.
1. To set PPPoE, connect PC to WIZ1000 directly and execute Configuration Tool program on
PC. (Configuration Tool version should be 2.1 or above)
2. Select ‘PPPoE’ of the “IP Configuration Method” tab and input ID & Password.
3. Click “setting” button to apply.
4. Connect Module to ADSL Line.
5. If “Enable Serial Debug Mode” is selected, you can see PPPoE access status
via Serial console.
IP Configuration Method: Select IP setting mode, you can select one from Static, DHCP,
displayed.
Figure 3. PPPoE Connection Process in Serial Console
WIZ1000 Ver. 01.00
--PHASE 0. PPPoE(ADSL) setup process--
--PHASE 1. PPPoE Discover process –- ok
--PHASE 2. LCP process –- ok
--PHASE 3. PPPoE(ADSL) Authentication mode --
Authentication protocol : c223 00,
--Waiting for PPPoE server’s admission -- ok
--PHASE 4. IPCP process --ok
WIZ1000 | 12 page