WIZ1000-US WIZnet, WIZ1000-US Datasheet - Page 16

• Manufacturer Part Number: WIZ1000-US
• Description: Ethernet Modules 1 PORT SERIAL-ENET DEVICE SERVER 110V
• Manufacturer: WIZnet

Specifications of WIZ1000-US

• Rohs: yes
• Product: Serial to Ethernet Servers
• Interface Type: RS-232
• Operating Supply Voltage: 5 V
• Maximum Operating Temperature: + 70 C
• Dimensions: 75 mm x 45 mm
• Minimum Operating Temperature: 0 C

Copyright © WIZnet All Rights Reserved
Check if module is connected to the NAT or private network. If so, it is not possible to
connect to the module from outside.
ⓜ
If there are more than one WIZ1000 in the same subnet with the same password, the function
of “Direct IP Address Search” will help users to get the specified WIZ1000 by input its IP
address directly.
ⓝ
This function is used for searching the connected WIZ1000s in the same sub-network. If you
want to configure or update the firmware of your WIZ1000, you have to find your WIZ1000 at
first. In order to protect WIZ1000 from attacking, a search password is needed to input in the
popup dialog after “Search” button clicked as shown in Figure 7. The password can be
modified by using this configuration tool and its maximum length is 8 bytes. Be sure to input
the correct password of your WIZ1000, otherwise, your device cannot be found. After
searching over,
default password is ‘wiznet’.
ⓞ
This function is to complete the configuration change.
If you select the MAC address from the “Board list”, the default configuration value of the
module will be displayed. Change the configuration and click “Setting” button to complete
the configuration. The module will re-initialize with the changed configuration. Changed
value is saved in the EEPROM of the module. Thus, the value is not removed even though
power is disconnected.
The configuration value can be changed in below steps.
Direct IP Address Search
Search
Setting
the MAC addresses of found WIZ1000s are listed in the “Board list”. The
Figure 7 Search password input dialog
WIZ1000 | 16 page